Graco 308395D- User Manual
Graco 308395D– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings; WARNING
- Page 4 – Installation; Grounding
- Page 5 – Typical Installation
- Page 6 – Installation Notes; Recommended Hydraulic Oil
- Page 7 – Operation; Pressure Relief Procedure; Emergency Stop Procedure
- Page 8 – Shutdown; Repair; Pressure Control Repair; Flow Control Repair
- Page 9 – Troubleshooting
- Page 10 – Parts
- Page 12 – Technical Data
- Page 13 – Notes
- Page 14 – Graco Standard Warranty; Graco Information
Instructions
Hydraulic Fluid
Controls
308395D
EN
Regulates hydraulic pressure and flow when used with Graco’s Dyna-Star
™
and
Power-Star
™
hydraulic-powered lubricant pumps. For professional use only.
Model 236864
Used with Dyna-Star
™
1500 psi (10.5 MPa, 105 bar)
Maximum Working Pres-
sure
3 gpm (11 liters/min) Maximum Flow Rate
Model 236865
Used with Power-Star
™
1500 psi (10.5 MPa, 150 bar)
Maximum Working Pres-
sure
12 gpm (45 liters/min) Maximum Flow Rate
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
Hydraulic fluid controls are designed to control
hydraulic fluids only in a hydraulic power system. Any
other fluids can cause unsafe operating conditions
and results in component rupture, fire, or explosion
which could result in serious injury, including fluid
injection.
Model 236865
Model 236864
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Warnings 2 308395D Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manua...
Installation 4 308395D Installation Grounding Pump: use ground wire and clamp (supplied). Loosen grounding lug locknut (W) and washer (V). Insert one end of a 12 ga (1.5 mm 2 ) minimum ground wire (Y) into the slot in lug (Z) and tighten the locknut securely. Con-nect the other end of the wire to a ...
Installation 308395D 5 Typical Installation Key: A Hydraulic Control, 236864 B Hydraulic Control, 236865 C Hydraulic Return Line D Hydraulic Outlet, 3/4 npsm (A), 1 1/4 npsm(B) E Return Line Shutoff Valve F Hydraulic Inlet, 3/8 npsm (A), 3/4 npsm (B) G Supply Line Shutoff Valve H Pressure Gauge J Pr...
