Graco 15V534 - Manual
Graco 15V534 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Contents; Related Manuals
- Page 3 – Installation; Location; Mount the Enclosure
- Page 4 – Install the Cable
- Page 5 – Install the Air Flow Switch
- Page 6 – Install the Pressure Switch
- Page 7 – Install the Solenoid
- Page 9 – Connect the Gun Flush Box; Connect Air Supply to Module
- Page 11 – Parts
- Page 13 – Dimensions
- Page 14 – Graco Standard Warranty
313212A
ENG
Instructions-Parts
15V534 Gun Flush
Box Interface Kit
Interfaces a Graco Gun Flush Box with a ProMix
®
2KS Electronic Proportioner using a
RoboMix Fluid Station. For professional use only.
Approved for use in explosive atmospheres only when used in conjunction with ProMix
2KS Electronic Proportioners.
100 psi (0.7 MPa, 7 bar) Maximum Air Input Pressure
Impor tant Safety Instructions
Read all warnings and instructions in this manual. For complete
warnings and instructions see your proportioning system manual
and gun flush box manual 312784. Hazard symbols refer to spe-
cific procedure risks. Save all instructions.
TI14275a
GFB Interface Kit shown with
two air flow switches installed
II 2 G
#
53
0359
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Related Manuals 2 313212A Contents Related Manuals . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Location . . . . . . . . . . . . . ...
Installation 313212A 3 Installation Location Install the gun flush box module enclosure (1) within 15 ft (4.5 m) of the RoboMix, to ensure that the cable (23) will reach the RoboMix. The module is approved for use in a hazardous location. See F IG . 1. Mount the Enclosure 1. See Dimensions, page 13....
Installation 4 313212A Install the Cable 1. Loosen the captive screws and remove the front cover from the enclosure. 2. The cable (23) has bare wires at both ends. Thread the shortest end (4 in. [102 mm]) into the enclosure through the strain relief bushing (7). See F IG . 2. 3. Connect the cable wi...
