GMC POL1450 - Manual - manualsarea.com

Page 2 - Contents

Contents Warranty 2 Introduction 3 Environmental protection 3 Description of symbols 3 Specifications 3 Safety instructions 4 Additional safety rules for sanders 5 Additional safety rules for angle grinders 6 Additional safety rules for polishers 7 Accessories 7 Unpacking 7 Know your product 8 Setti...

Page 3 - Description of symbols; Double insulated for additional protection.; Specifications; Double Insulated; Dear Customer; Carefully read through this entire Instruction; Environmental protection

Description of symbols The rating plate on your tool may show symbols. Theserepresent important information about the product orinstructions on its use. Wear hearing protection. Wear eye protection. Wear breathing protection. Double insulated for additional protection. Conforms to relevant standards...

Page 4 - Safety instructions; Consider the environment in which you are working.

Safety instructions The tool must be used only for the prescribed purpose.Any uses other than those mentioned in this manual willbe considered a case of misuse. The user and not themanufacturer shall be liable for any damage or injuryresulting from such cases of misuse.To use this tool properly, you...

Page 5 - Additional safety rules for angle grinders

9. Connect dust extraction equipment. If devices are provided for the connection of dust extraction andcollection facilities, ensure that these are connectedand properly used. 10. Do not abuse the power cord. Never pull the cord to disconnect the tool from the power point. Keep thecord away from hea...

Page 6 - Additional safety rules for sanders; Before connecting a tool to a power source

6 • Check the disc before mounting it into the anglegrinder. Check by striking it with a wooden handlewhilst balancing the disc on your finger. Listen for thering and do not use if dull, as the disc may be cracked. • When the disc is installed, run it for at least one minuteto ensure that it does no...

Page 8 - Know your product; the multi position front handle; Disc assembly; Grinder

Know your product Before using the polisher, familiarise yourself with all the operating features and safety requirements.Use the tool and accessories only for the applications intended. All other applications are expressly ruled out.1. Motor housing2. Spindle lock button3. Variable speed dial4. Rea...

Page 9 - Setting up; Multi position front handle; Variable Speed; Fitting the grinding disc

Setting up Multi position front handle Screw the multi position fronthandle (9) into the mostsuitable mounting point (6)(left side, right side or at thetop) to suit the task on hand. Variable Speed The POL1450 is fitted with avariable speed dial (3) thatallows you to adjust the speedto suit the appl...

Page 11 - Operation in sander mode; Fitting the Sandpaper

11 Operation in sander mode Fitting the Sandpaper Switch off the tool and disconnect it from the powersupply.1. The GMC grinder/sander/polisher is fitted with a hook & loop base allowing easy changing of accessories.Ensure there are no debrisleft in the hooks & loops ofthe disc before fittin...

Page 12 - Operation in polisher mode; Prepare the surface

12 Operation in polisher mode Prepare the surface For best results, the surface should be clean and dry. Mosthigh-gloss surfaces can be cleaned with a mild soap andwater solution. For removal of stubborn dirt stains such asroad tar, grease, and bug stains, you can use a mildammonia solution such as ...

Page 16 - GMC Product Type; Save this Manual for future reference.

Carefully read the entire Instruction Manual before using this product. Before returning this product for a Warranty Claim or any other reason Please Call 1300 880 001 (Australia)or 0800 445 721 (New Zealand) When you make your call, please have the following information at hand: • GMC Product Type ...

GMC POL1450 - Manual

Table of Contents:

Summary

Other GMC Models