GMC LSM210A Manual - Free PDF Download

Page 2 - Contents; Warranty Powertools

2 Contents Warranty Powertools Whilst every effort is made to ensure your complete satisfaction with this tool, occasionally, due to the mass manufacturing techniques, a tool may not live up to our required level of performance and you may need the assistance of our service department.This product i...

Page 6 - Additional safety rules for mitre saws

6 13. Disconnect idle tools. Switch off the power and disconnect the plug from the power point before servicing, when changing accessories and when the tool is not in use. 14. Remove adjusting keys and wrenches. Check to see that keys and adjusting wrenches are removed from the tool before switching...

Page 8 - Accessories

8 Accessories The GMC LSMS210A and LSMS250A slide compound mitre saws are supplied with the following accessories as standard: • Saw blade (fitted) • Workpiece clamp • 6mm Hex key • Side bars x2 • Dust bag • Instruction manual

Page 9 - Know your product

9 Know your product Before using the saw, familiarise yourself with all the operating features and safety requirements.1. Laser light assembly 2. Laser light on/off switch 3. Laser cover 4. Laser pitch control 5. Saw arm 6. Release knob 7. Operating handle 8. Carrying handle 9. Upper fixed blade gua...

Page 13 - Setting the fence square with the table

13 T 6. Loosen the bevel lock (16) and set the saw arm (5) at 0º bevel (the blade at 90º to the mitre table). Tighten the bevel lock (16) (Fig. S). 7. Place a set square against the table (21) and the flat part of the blade. Note. Make sure that the square contacts the flat part of the saw blade, no...

Page 14 - Changing a blade

14 Changing a blade DANGER! Never try to use a blade larger than the stated capacity of the saw. It might come into contact with the blade guards. Never use a blade that is too thick to allow the outer blade washer to engage with the flats on the spindle. It will prevent the blade screw from properl...

Page 16 - Bevel cut

16 12. Release the switch trigger (24) and allow the saw blade to stop rotating before raising the blade out of the workpiece. Wait until the blade stops before removing the workpiece (Fig. k). Cross-cutting (with slide action) When cutting wide workpieces, first unscrew the slide lock (29).1. Pull ...

Page 20 - GMC customer assist

GMC customer assist If your product needs repairing, replacing, technical service or you simply need help or advice, please contact us on our Customer Assist Line 1300 880 001 (Australia) or 0800 445 721 (New Zealand). For prompt service we suggest you log your service request online at www.gmcservi...