GMC LTP25SS - Manual - manualsarea.com

Page 2 - Contents; Warranty Power Tools

2 Contents Warranty Power Tools Whilst every effort is made to ensure your complete satisfaction with this tool, occasionally, due to the mass manufacturing techniques, a tool may not live up to our required level of performance and you may need the assistance of our service department.This product ...

Page 3 - Description of symbols; Dear Customer

3 Description of symbols The rating plate on your tool may show symbols. These represent important information about the product or instructions on its use. Conforms to relevant standards for electromagnetic compatibility. Wear hearing protection. Wear eye protection. Wear breathing protection. Wear...

Page 6 - Know your product

6 Know your product 1. Cutting line spool and assembly2. Cut off knife3. Safety guard4. Handle5a. Upper shaft5b. Lower shaft6. Ignition switch7. Fuel tank8. Throttle lever9. Recoil starter10. Primer11. Spark plug12. Filter cover13. Safety lever14. Choke lever15. Handle locking knob16. Spark plug wre...

Page 7 - Assembly

7 Assembly Prior to use, it is necessary to assemble the safety guard (3) and cutting spool (1) to the lower shaft (5b) and join the lower shaft (5b) to the upper shaft (5a).Before assembling the line trimmer, ensure the protective plastic sleeve is removed from the shaft of the trimmer. Fitting the...

Page 12 - Maintenance

12 8. When there is approximately 150mm of line left, lock one of the lines into one of the line location notches in the spool head and the other into the opposing notch. 9. With the spring fitted onto the shaft of the spool holder insert the spool back into the holder. As you insert the spool, thre...

Page 13 - Storage and maintenance after use

13 Checking the spark plug Check the spark plug every 10–15 hours of use. 1. Remove the spark plug cover.2. Use the spark plug wrench to remove the spark plug, by turning it counter-clockwise. 3. Clean and adjust the spark plug gap to 0.6 – 0.7mm. Replace any damaged or visibly worn plug with a NGK ...

Page 14 - Problems

14 Problems Power loss or sudden stopping of the engine • Check whether the fuel tank is empty. • The mixture does not reach the carburettor. Clean the fuel filter in the fuel tank. • There is water in the mixture. Drain and rinse all the fuel system. • The air filter is dirty. Clean the air filter....

Page 16 - GMC customer assist; Should you not have

GMC customer assist If your product needs repairing, replacing, technical service or you simply need help or advice, please contact us on our Customer Assist Line 1300 880 001 (Australia) or 0800 445 721 (New Zealand). For prompt service we suggest you log your service request online at www.gmcservi...

GMC LTP25SS - Manual

Table of Contents:

Summary

Other GMC Models