GE ZDBR240PBS - Manual

ZDBR240PBS – GE Monogram Beverage Center with Digital Controls

Dimensions and Specifications (in inches)
Installation Space

The Monogram

®

Beverage Center may be installed beneath a

countertop or can be used free-standing.
• If installing between frameless cabinets, a 1/2"-wide filler strip

or side panel may be required. The filler strip will act as a spacer

between the door case and adjacent cabinet and will prevent

interference with cabinet door swing. The width of the opening

must include filler panels.

Note:

When installed, the door should project forward 1" of

adjacent 24"-deep cabinets.

Location Requirements

All Monogram Refrigeration Modules may be closed in on the top

and sides as long as the front is unobstructed for air circulation and

door swing.
• Do not install these products where the temperatures will go

below 55°F (13°C) or above 90°F (32°C).

• Do not install where they will be subject to direct sunlight,

heat or moisture.

• These products are not designed to be stacked one over the other.

For answers to your Monogram,

®

GE Profile

™

or

GE

®

appliance questions, visit our website at

GEAppliances.com or call GE Answer Center

®

service, 800.626.2000.

Listed by

Underwriters

Laboratories

34-1/2"-35"

24" Min.

23-3/4"

25-1/2"

Including

Handle

23-3/4"

1-1/2"

Locate Outlet

9"

Max.

10-1/2"

23-3/4" Min.

34-1/4"

to

34-3/4"

Specification Revised 12/06

120038

Side-by-Side Installation

For a complete refreshment center, install a Monogram Wine Reserve

and Beverage Center together.
• Products must operate from separate properly grounded

receptacles.

Door Swing Clearances

All Monogram Refrigeration Modules are factory set for a 110°

door swing.
When installed in a corner:
• Allow the minimum door swing clearances shown.
• The minimum clearance shown at 90° will allow full extension

of drawers and shelves.

A

Minimum to Wall

110

°

110

°

Door

Swing

21-5/8"

23-5/8"

B

Minimum to Wall

90

°

90

°

Door

Swing

10"

Minimum to Wall

4"

Minimum to Wall

Electrical

A 120V, 60Hz, 15 or 20 amp power supply is required. An individual

properly grounded branch circuit or circuit breaker is recommended.

Install a properly grounded 3-prong electrical recessed into the

back wall as shown. Electrical must be located on rear wall as shown.

Note:

GFCI (ground fault circuit interrupter) is not recommended.