GE GTD65EBSJ4WS - Installation Manual
GE GTD65EBSJ4WS – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation Instructions; Tilt the dryer sideways and remove the foam; UNPACKING YOUR DRYER; Side View; State of California Proposition 65 Warnings; WARNING
- Page 3 – DO NOT
- Page 4 – WATER SUPPLY REQUIREMENTS
- Page 5 – TOOLS YOU WILL NEED; CONNECTING A GAS DRYER (skip for electric dryers); MATERIALS YOU WILL NEED
- Page 6 – GAS REQUIREMENTS; DOES NOT; FOR USE WITH NATURAL GAS ONLY
- Page 7 – CONNECTING THE DRYER TO THE GAS
- Page 8 – TEST FOR LEAKS; GROUNDING INSTRUCTIONS
- Page 9 – NEVER LEAVE THE
- Page 10 – SAVE THESE INSTRUCTIONS
- Page 11 – CONNECTING DRYER USING 3-WIRE; NEVER LEAVE THE COVER OFF OF THE TERMINAL
- Page 12 – PARTS AVAILABLE FROM GEAPPLIANCES.COM
- Page 13 – The correct exhaust installation is YOUR; EXHAUST LENGTH; DO NOT; DO
- Page 14 – BEFORE YOU BEGIN
- Page 15 – SIDE OR BOTTOM VENTING; Be sure not to pull or damage the electrical wires
- Page 16 – ADDING COVER PLATE TO REAR OF CABINET; ADDING ELBOW FOR EXHAUST THROUGH; FINAL SETUP; LEVEL THE DRYER; Power
- Page 17 – ABOUT REVERSING THE DOOR; Before you start; Choose the; REVERSING THE DOOR; instructions; REVERSING THE DOOR - SOLID DOOR
- Page 18 – When you finish
- Page 19 – REVERSING THE DOOR - GLASS PANEL
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
–
Save these instructions for local
electrical inspector’s use.
•
IMPORTANT
–
Observe all governing codes and
ordinances.
•
Install the clothes dryer according to the manufacturer’s
instructions and local codes.
•
Note to Installer –
Be sure to leave these instructions
with the Consumer.
•
Note to Consumer –
Keep these instructions for future
reference.
•
Clothes dryer installation must be performed by a
qualified installer.
•
This dryer
must
be exhausted to the outdoors.
•
Before the old dryer is removed from service or
discarded, remove the dryer door.
•
Service information and the wiring diagram are located
in the control console.
•
Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
•
Proper installation is the responsibility of the installer.
•
Product failure due to improper installation is not
covered under the Warranty
.
•
Install the dryer where the temperature is above 50°F
for satisfactory operation of the dryer control system.
• Remove and discard existing plastic or metal foil duct
and replace with UL-listed duct.
Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com
- Fire Hazard
WARNING
•
Clothes dryer installation must be performed by a
qualified installer.
•
Install the clothes dryer according to these
instructions and local codes.
•
DO NOT
install a clothes dryer with flexible plastic
venting materials. If flexible metal (semi-rigid or
foil-type) duct is installed, it must be UL-listed and
installed in accordance with the instructions found
in “Connecting the Dryer to House Vent” later in
this manual. Flexible venting materials are known
to collapse, be easily crushed and trap lint. These
conditions will obstruct dryer airflow and increase
the risk of fire.
•
DO NOT
install or store this appliance in any
location where it could be exposed to water or
weather.
•
To reduce the risk of severe injury or death, follow
all installation instructions.
•
Save these instructions. (Installers: Be sure to leave
these instructions with the customer.)
Installation Dryers
Instructions
05
31-16775-3
12-16
GEA
Printed in Mexico
234D2318P005
IN THE COMMONWEALTH OF
MASSACHUSETTS, THE FOLLOWING
INSTALLATION INSTRUCTIONS APPLY:
•
Installation must be performed by a qualified
or licensed contractor, plumber, or gasfitter
qualified or licensed by the State.
•
If using a ball valve, it shall be a T-handle type.
•
A flexible gas connector, when used, must not
exceed 3 feet.
FOR GAS DRYERS ONLY
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Was this manual helpful?
About this manual
- Brand
- GE
- Model
- GTD65EBSJ4WS
- Document type
- Installation Manual
- Language(s)
- English
- Pages
- 20
- File size
- 2.5 MB
- Format
Other Manuals for GE GTD65EBSJ4WS
Summary
Installation Instructions Tilt the dryer sideways and remove the foam shipping pads by pulling at the sides and breaking them away from the dryer legs. Be sure to remove all of the foam pieces around the legs.Remove literature and bag containing accessories. UNPACKING YOUR DRYER STEAM WATER HOSES: G...
Installation Instructions 3 MOBILE OR MANUFACTURED HOME INSTALLATION POWER CORDS: GE Appliances strongly recommends the use of factory specified parts. Select the power cord to fit your installation requirements.Order on-line at GEApplianceParts.com , 24 hours a day or by phone at 800.626.2002 durin...
To produce steam, the dryer must connect to the cold water supply. Since the washer must also connect to the cold water, a “Y” connector is inserted to allow both inlet hoses to make that connection at the same time. NOTE: Use the new inlet hoses provided; never use old hoses. 1 . Turn the cold wate...
Ask a question
Related manuals
Popular GE Other
More GE Other models
GE GTD42EASJ2WW Installation Manual- GE GTD42GASJ2WW Installation Manual
- GE GTD45EASJ2WS Installation Manual
- GE GTD45GASJ2WS Installation Manual
GE GTD65EBSJ2WS Installation Manual- GE GTD65EBSJ3WS Installation Manual
- GE GTD65GBSJ3WS Installation Manual
GE GTD72EBPN0DG Installation Manual- GE GTD72EBSN0WS Installation Manual
- GE GTD72GBPN0DG User Manual
- GE GTD72GBSN0WS Installation Manual
GE GTD75ECPL0DG Installation Manual