GE GSD3360K65SS - Installation Manual

READ CAREFULLY

KEEP THESE INSTRUCTIONS

CHECK THE FOLLOWING

Dishwasher is square and level at both the top and
bottom of the cabinet opening, with no twisting or
distortion of the tub or door.

All 4 legs of the dishwasher are firmly in contact with
the floor.

Drain hose is not pinched between the dishwasher
and adjacent cabinets or walls.

FOR YOUR SAFETY

Read and observe all WARNINGS and CAUTIONS
shown throughout these instructions.

While performing installations described in this
booklet, gloves, safety glasses or goggles should
be worn.
IMPORTANT –

Observe all governing codes and

ordinances.
•

Note to Installer

– Be sure to leave these instructions

for the consumer’s and local inspector’s use.

•

Note to Consumer

– Keep these instructions with

your Owner’s Manual for future reference.

•

Skill Level

– Installation of this dishwasher requires

basic mechanical, electrical and plumbing skills.

Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the Warranty. See Warranty
information.

•

Completion Time – 1 to 3 Hours

. New installations

require more time than replacement installations.

IMPORTANT –

The dishwasher MUST be installed to

allow for future removal from the enclosure if service is

required.
Care should be exercised when the appliance is installed
or removed, to reduce the likelihood of damage to the
power supply cord.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories – See the Owner’s Manual for
available custom panel kits.
Your dishwasher is a water heating appliance.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

31-31587-2

02-19 GEA

•

Remove all power leading to the appliance from the

circuit breaker or fuse box before beginning installation.

Failure to do so can result in a risk of electrical shock.

•

To reduce the risk of electric shock, fire, or injury to persons,

the installer must ensure that the dishwasher is completely

enclosed at the time of installation.

•

The improper connection of the equipment grounding

conductor can result in a risk of electric shock. Check

with a qualified electrician or service representative

if you are in doubt that the appliance is properly

grounded. If house wiring is not 2-wire with ground, a

ground must be by the installer. When house wiring

is aluminum, be sure to use UL-Listed anti-oxidant

compound and aluminum-to-copper connectors.

•

To reduce the risk of electric shock, fire, or injury to

persons, the installer should check to ensure that wires are

not pinched or damaged, the house wiring is attached to the

junction box bracket through a strain relief, and all electrical

connections made at the time of install (wire nuts) are

contained inside of the junction box cover.

WARNING

•

Retire todos los conductores de corriente del

electrodoméstico de disyuntor o de la caja del fusible

antes de comenzar con la instalación. Si no cumple con

esto, se podrá producir el riesgo de descargas eléctricas.

•

Para reducir el riesgo de descarga eléctrica, incendio

o lesiones a personas, el instalador debe asegurarse

de que el lavaplatos esté completamente cerrado en

el momento de la instalación.

•

La conexión inadecuada del conductor de conexión a

tierra del equipamiento puede provocar un riesgo de

descarga eléctrica. Consulte a un electricista calificado

o representante de servicio técnico si tiene dudas

sobre la correcta conexión a tierra del aparato. Si el

cableado doméstico no cuenta con un cable de 2 hilos

con conexión a tierra, un instalador debe realizar una

conexión a tierra. Cuando el cableado doméstico es de

aluminio, asegúrese de usar un compuesto antioxidante

y conectores de aluminio a cobre aprobados por UL.

•

Para reducir el riesgo de descarga eléctrica, incendio

o lesiones a personas, el instalador deberá realizar un

control para asegurar que los cables no estén pellizcados

ni dañados, que el cableado del hogar esté conectado a la

ficha de la caja de empalmes a través de un amortiguador

de refuerzo, y que todas las conexiones eléctricas

realizadas en el momento de la instalación (tuercas para

cables) estén dentro de la tapa de la caja de empalmes.

ADVERTENCIA

See your Owner’s Manual for details on how to contact us regarding installation questions

Built-In & Spacemaker

®

Dishwashers

Installation

Instructions