GE GTD42GASJ2WW - Installation Manual

GE GTD42GASJ2WW

GE GTD42GASJ2WW – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
Page: / 40

Table of Contents:

  • Page 2 – Installation Instructions; Tilt the dryer sideways and remove the foam; UNPACKING YOUR DRYER; DIMENSIONS; Side View; State of California Proposition 65 Warnings:; WARNING
  • Page 3 – NOTE: WHEN THE EXHAUST DUCT IS LOCATED IN
  • Page 4 – WATER SUPPLY REQUIREMENTS
  • Page 5 – TOOLS YOU WILL NEED; CONNECTING A GAS DRYER (skip for electric dryers); MATERIALS YOU WILL NEED
  • Page 7 – NOTE: Apply pipe compound or PTFE tape; CONNECTING THE DRYER TO THE GAS; IMPORTANT: Use a pipe wrench to securely hold
  • Page 8 – TEST FOR LEAKS; Never use an open flame to test for gas leaks.; ELECTRICAL CONNECTION; - Electrical Shock Hazard
  • Page 9 – NEVER LEAVE THE
  • Page 10 – For a permanently connected dryer: This
  • Page 11 – CONNECTING DRYER USING 3-WIRE; NEVER LEAVE THE COVER OFF OF THE TERMINAL
  • Page 12 – RIGID METAL TRANSITION DUCT; PARTS AVAILABLE FROM LOCAL
  • Page 13 – The correct exhaust installation is YOUR; EXHAUST LENGTH; DO cut duct as short
  • Page 14 – BEFORE YOU BEGIN
  • Page 15 – SIDE OR BOTTOM VENTING; Be sure not to pull or damage the electrical wires
  • Page 16 – ADDING COVER PLATE TO REAR OF CABINET; FINAL SETUP; LEVEL THE DRYER; Power
  • Page 17 – ABOUT REVERSING THE DOOR; Before you start; REVERSING THE DOOR - SOLID DOOR
  • Page 18 – When you finish
  • Page 19 – REVERSING THE DOOR - GLASS PANEL
  • Page 21 – Instrucciones; ANTES DE COMENZAR; PELIGRO
  • Page 22 – Instrucciones de instalación; CÓMO DESEMPACAR LA SECADORA; Incline la secadora de costado y saque los paños de; Advertencias de la Proposición 65 del Estado de California:
  • Page 23 – - Riesgo de explosión; NOTA: CUANDO EL CONDUCTO DE ESCAPE SE
  • Page 24 – CÓMO CONECTAR MANGUERAS
  • Page 25 – HERRAMIENTAS NECESARIAS
  • Page 27 – NOTA: Aplique compuesto para tubería o cinta; CÓMO CONECTAR LA SECADORA; IMPORTANTE: Utilice una llave para tubos para
  • Page 28 – PRUEBA DE PÉRDIDAS; Nunca utilice una llama abierta para detectar; CONEXIÓN ELÉCTRICA INFORMACIÓN; - Riesgo de Descarga Eléctrica
  • Page 29 – MATERIALES NECESARIOS
  • Page 30 – Para una secadora conectada con cable con
  • Page 31 – NUNCA OLVIDE DE VOLVER A COLOCAR LA TAPA
  • Page 32 – HERRAMIENTAS Y MATERIALES NECESARIOS
  • Page 33 – La correcta instalación de salida es SU; LONGITUD DE SALIDA; NO doble o; LONGITUD DE ESCAPE
  • Page 35 – VENTILACIÓN LATERAL O POR LA PARTE; Asegúrese de no tirar o dañar los cables eléctricos
  • Page 36 – CONFIGURACIÓN FINAL; INICIO DE LA SECADORA; NOTA: Si la secadora ha sido expuesta a temperaturas; SALIDA AL EXTERIOR DE LA
  • Page 37 – Cómo cambiar el sentido de apertura; Antes de Comenzar; Elija las INVERSIÓN DE LA PUERTA instrucciones
  • Page 38 – INVERSIÓN DE LA PUERTA - MODELOS DE; Al finalizar
  • Page 39 – INVERSIÓN DE LA PUERTA - MODELOS CON; INVERSIÓN DE LA PUERTA
Loading the manual

BEFORE YOU BEGIN

Read these instructions completely and carefully.
•

IMPORTANT

– Save these instructions for local

electrical inspector’s use.

•

IMPORTANT

– Observe all governing codes and

ordinances.

•

Install the clothes dryer according to the manufacturer’s

instructions and local codes.

•

Note to Installer – Be sure to leave these instructions

with the Consumer.

•

Note to Consumer – Keep these instructions for future

reference.

•

Clothes dryer installation must be performed by a

qualified installer.

•

This dryer must be exhausted to the outdoors.

•

Before the old dryer is removed from service or

discarded, remove the dryer door.

•

Service information and the wiring diagram are located

in the control console.

•

Do not allow children on or in the appliance. Close

supervision of children is necessary when the appliance

is used near children.

•

Proper installation is the responsibility of the installer.

•

Product failure due to improper installation is not

covered under the Warranty

.

•

Install the dryer where the temperature is above 50°F

for satisfactory operation of the dryer control system.

• Remove and discard existing plastic or metal foil duct

and replace with UL-listed duct.

Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com

- Fire Hazard

WARNING

•

Clothes dryer installation must be performed by a

qualified installer.

•

Install the clothes dryer according to these

instructions and local codes.

•

DO NOT install a clothes dryer with flexible plastic

venting materials. If flexible metal (semi-rigid or

foil-type) duct is installed, it must be UL-listed and

installed in accordance with the instructions found

in “Connecting the Dryer to House Vent” later in

this manual. Flexible vent materials are known to

collapse, be easily crushed and trap lint. These

conditions will obstruct dryer airflow and increase

the risk of fire.

•

DO NOT install or store this appliance in any

location where it could be exposed to water or

weather.

•

To reduce the risk of severe injury or death, follow

all installation instructions.

•

Save these instructions. (Installers: Be sure to leave

these instructions with the customer.)

Installation Dryers

Instructions

05

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill you or hurt you and others.

All safety messages will follow the safety alert symbol and the word “DANGER”, “WARNING”, or “CAUTION”. These

words are defined as:

Indicates a hazardous situation which, if not avoided, will result in death or serious injury.

Indicates a hazardous situation which, if not avoided, could result in death or serious injury.

Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.

DANGER
WARNING
CAUTION

31-16775-2

04-16 GE

Printed in Mexico

234D2318P005

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for GE GTD42GASJ2WW

Summary

Page 2 - Installation Instructions; Tilt the dryer sideways and remove the foam; UNPACKING YOUR DRYER; DIMENSIONS; Side View; State of California Proposition 65 Warnings:; WARNING

Installation Instructions Tilt the dryer sideways and remove the foam shipping pads by pulling at the sides and breaking them away from the dryer legs. Be sure to remove all of the foam pieces around the legs.Remove literature and bag containing accessories. UNPACKING YOUR DRYER STEAM WATER HOSES: G...

Page 3 - NOTE: WHEN THE EXHAUST DUCT IS LOCATED IN

Installation Instructions 3 MOBILE OR MANUFACTURED HOME INSTALLATION POWER CORDS: GE strongly recommends the use of factory specified parts. Select the power cord to fit your installation requirements.Order on-line at GEApplianceParts.com, 24 hours a day or by phone at 800.626.2002 during normal bus...

Page 4 - WATER SUPPLY REQUIREMENTS

To produce steam, the dryer must connect to the cold water supply. Since the washer must also connect to the cold water, a “Y” connector is inserted to allow both inlet hoses to make that connection at the same time.NOTE: Use the new inlet hoses provided; never use old hoses.1. Turn the cold water f...

Other GE Models