GE Built-In Dishwasher - User Manual

GE Built-In Dishwasher

GE Built-In Dishwasher – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
Page: / 12

Table of Contents:

  • Page 2 – Installation Preparation; For New Installations Only:; Carpenters Square; Flashlight; Nutdriver; Screw Driver II; Tubing Cutter; Waste Tee; Crescent Wrench; Wood Screw
  • Page 3 – PREPARE DISHWASHER ENCLOSURE; WARNING; DRAIN REQUIREMENTS; If the answer to either question is YES, Method 1 MUST; CABINET PREPARATION; MUST; Countertop; MUST BE USED
  • Page 4 – PREPARE ELECTRICAL WIRING
  • Page 5 – Installation Instructions; PREPARE HOT WATER LINE; Water Line Connection; Do not open the door; STOP; BEFORE YOU BEGIN; STEP 1 CHECK DOOR BALANCE; Increase
  • Page 6 – STEP 2 ADJUST LEVELING LEGS; STEP 3 REMOVE TOEKICK; Skip this step if dishwasher will be direct wired.; STEP 5 INSTALL 90° ELBOW
  • Page 7 – Position water line and house wiring on the floor; DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.; Water
  • Page 8 – Figure T; STEP 9 POSITION DISHWASHER UNDER; IMPORTANT; the controls and the underside of the countertop to prevent; Figure S; Top View
  • Page 9 – STEP 10 LEVEL DISHWASHER; – After leveling, verify that the; STEP 11 SECURE DISHWASHER TO; Screws
  • Page 10 – STEP 12 CONNECT WATER SUPPLY; STEP 13 CONNECT DRAIN LINE; FOLLOW ALL LOCAL CODES AND ORDINANCES.; Method 2 – Drain Hose Routing; – Either one of the above methods; DRAIN LINE INSTALLATION
  • Page 11 – STEP 14 CONNECT POWER SUPPLY; Skip this step if equipped with power cord.; STEP 15 PRETEST CHECK LIST; Review this list after installing your dishwasher to avoid
  • Page 12 – STEP 16 DISHWASHER WET TEST; STEP 17 REPLACE TOEKICK
Loading the manual

GE Consumer & Industrial

Appliances

Installation Instructions

Built-In Dishwasher

If you have questions, call 800.GE.CARES (800.432.2737) or visit our website at: www.ge.com

imagination at work

IMPORTANT

– The dishwasher MUST

be installed to allow for future removal from the enclosure
if service is required.

If you received a damaged dishwasher, you should
immediately contact your dealer or builder.

Optional Accessories – See the Owner’s Manual for available
custom panel kits.

FOR YOUR SAFETY

Read and observe all CAUTIONS and WARNINGS

shown throughout these instructions. While performing

installations described in this booklet , gloves and either

safety glasses or goggles should be worn.

READ CAREFULLY.

KEEP THESE INSTRUCTIONS.

IMPORTANT

– Observe all governing codes and

ordinances.

Note to Installer

– Be sure to leave these instructions for the

consumer’s and local inspector’s use.

Note to Consumer

– Keep these instructions with your

Owner’s Manual for future reference.

Skill Level

– Installation of this dishwasher requires

basic mechanical, electrical and plumbing skills.

Proper

installation is the responsibility of the installer. Product

failure due to improper installation is not covered under

the GE Appliance Warranty. See warranty information.

Completion Time – 1 to 3 Hours

. New installations require

more time than replacement installations.

BEFORE YOU BEGIN

Read these instructions completely and
carefully.

STOP

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Was this manual helpful?

About this manual

Brand
GE
Model
Built-In Dishwasher
Document type
User Manual
Language(s)
English
Pages
12
File size
1.6 MB
Format
PDF

Other Manuals for GE Built-In Dishwasher

Summary

Page 2 - Installation Preparation; For New Installations Only:; Carpenters Square; Flashlight; Nutdriver; Screw Driver II; Tubing Cutter; Waste Tee; Crescent Wrench; Wood Screw

PARTS SUPPLIED: ■ Two #8 Phillips head wood screws, 5/8" long to Two #8 Phillips head wood screws, 5/8" long to secure dishwasher to underside of countertop (in literature package). Installation Preparation TOOLS YOU WILL NEED: ■ Phillips head screwdriver Phillips head screwdriver ■ 5/16"...

Page 3 - PREPARE DISHWASHER ENCLOSURE; WARNING; DRAIN REQUIREMENTS; If the answer to either question is YES, Method 1 MUST; CABINET PREPARATION; MUST; Countertop; MUST BE USED

Installation Preparation PREPARE DISHWASHER ENCLOSURE • The rough cabinet opening must be at least 24" deep, 17-5/8" to 18" wide and approximately 34-1/2" high from fl oor to underside of the countertop. • The dishwasher must be installed so that drain hose is no more than 10’ in leng...

Page 4 - PREPARE ELECTRICAL WIRING

Installation Preparation PREPARE ELECTRICAL WIRING #282 French FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning installation. Do not use an extension cord or adapter plug with this appliance. #282 French The improper connection of the equipment grounding conductor can ...

Ask a question

Up to 3 photos. Max 5 MB each. Formats: JPG, JPEG, PNG, WebP.