GE Built-In Dishwasher - Manual
GE Built-In Dishwasher – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation Preparation; For New Installations Only:; Carpenters Square; Flashlight; Nutdriver; Screw Driver II; Tubing Cutter; Waste Tee; Crescent Wrench; Wood Screw
- Page 3 – PREPARE DISHWASHER ENCLOSURE; WARNING; DRAIN REQUIREMENTS; If the answer to either question is YES, Method 1 MUST; CABINET PREPARATION; MUST; Countertop; MUST BE USED
- Page 4 – PREPARE ELECTRICAL WIRING
- Page 5 – Installation Instructions; PREPARE HOT WATER LINE; Water Line Connection; Do not open the door; STOP; BEFORE YOU BEGIN; STEP 1 CHECK DOOR BALANCE; Increase
- Page 6 – STEP 2 ADJUST LEVELING LEGS; STEP 3 REMOVE TOEKICK; Skip this step if dishwasher will be direct wired.; STEP 5 INSTALL 90° ELBOW
- Page 7 – Position water line and house wiring on the floor; DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.; Water
- Page 8 – Figure T; STEP 9 POSITION DISHWASHER UNDER; IMPORTANT; the controls and the underside of the countertop to prevent; Figure S; Top View
- Page 9 – STEP 10 LEVEL DISHWASHER; – After leveling, verify that the; STEP 11 SECURE DISHWASHER TO; Screws
- Page 10 – STEP 12 CONNECT WATER SUPPLY; STEP 13 CONNECT DRAIN LINE; FOLLOW ALL LOCAL CODES AND ORDINANCES.; Method 2 – Drain Hose Routing; – Either one of the above methods; DRAIN LINE INSTALLATION
- Page 11 – STEP 14 CONNECT POWER SUPPLY; Skip this step if equipped with power cord.; STEP 15 PRETEST CHECK LIST; Review this list after installing your dishwasher to avoid
- Page 12 – STEP 16 DISHWASHER WET TEST; STEP 17 REPLACE TOEKICK
GE Consumer & Industrial
Appliances
Installation Instructions
Built-In Dishwasher
If you have questions, call 800.GE.CARES (800.432.2737) or visit our website at: www.ge.com
imagination at work
IMPORTANT
– The dishwasher MUST
be installed to allow for future removal from the enclosure
if service is required.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories – See the Owner’s Manual for available
custom panel kits.
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS
shown throughout these instructions. While performing
installations described in this booklet , gloves and either
safety glasses or goggles should be worn.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
IMPORTANT
– Observe all governing codes and
ordinances.
•
Note to Installer
– Be sure to leave these instructions for the
consumer’s and local inspector’s use.
•
Note to Consumer
– Keep these instructions with your
Owner’s Manual for future reference.
•
Skill Level
– Installation of this dishwasher requires
basic mechanical, electrical and plumbing skills.
Proper
installation is the responsibility of the installer. Product
failure due to improper installation is not covered under
the GE Appliance Warranty. See warranty information.
•
Completion Time – 1 to 3 Hours
. New installations require
more time than replacement installations.
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
STOP
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Was this manual helpful?
About this manual
- Brand
- GE
- Model
- Built-In Dishwasher
- Document type
- Manual
- Language(s)
- English
- Pages
- 12
- File size
- 1.6 MB
- Format
Other Manuals for GE Built-In Dishwasher
Summary
PARTS SUPPLIED: ■ Two #8 Phillips head wood screws, 5/8" long to Two #8 Phillips head wood screws, 5/8" long to secure dishwasher to underside of countertop (in literature package). Installation Preparation TOOLS YOU WILL NEED: ■ Phillips head screwdriver Phillips head screwdriver ■ 5/16"...
Installation Preparation PREPARE DISHWASHER ENCLOSURE • The rough cabinet opening must be at least 24" deep, 17-5/8" to 18" wide and approximately 34-1/2" high from fl oor to underside of the countertop. • The dishwasher must be installed so that drain hose is no more than 10’ in leng...
Installation Preparation PREPARE ELECTRICAL WIRING #282 French FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning installation. Do not use an extension cord or adapter plug with this appliance. #282 French The improper connection of the equipment grounding conductor can ...
