Furuno GP-90 - Manual

Furuno GP-90

Furuno GP-90 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
Page: / 36

Table of Contents:

  • Page 2 – SAFETY INSTRUCTIONS; WARNING; Use the correct fuse.; CAUTION
  • Page 3 – LIST; Standards; For DGPS; Options
  • Page 4 – UNIT; Locate the unit away from exhaust pipes and vents.; Table Top and Overhead Mounting; Display unit mounting methods; Flush mounting type F; Flush mounting type S; Name Type
  • Page 5 – Mounting; Select a location out of the radar beam.; The radar beam will obstruct or prevent reception; Be sure the location offers a clean line-of-sight to satellite.; Mounting the antenna as high as possible keeps it free; The antenna unit GPA-018S must be grounded.; Connect ground wire of 1.25 sq or larger; The antenna unit GPA-018S must be taped.; See chapter 7 for instructions.; Extending Antenna Cable Length; Extension cable line-up
  • Page 7 – Connection of cables on display unit
  • Page 8 – Grounding; The grounding wire should be 1.25sq or larger.; External Equipment; Connection of DATA4 port; In case of RS-422 Level
  • Page 9 – SETTINGS; Checking Operation; Self-test display at equipment start up; DGPS Setup; Automatic DGPS setup; Figure 5-1 DGPS SETUP menu
  • Page 11 – Input/Output Setting; Talker
  • Page 12 – Data format and data output availability; RMC: Recommended minimum specific GPS/TRANSIT data
  • Page 14 – General data; ) Input of waypoint data; Rate of operation
  • Page 15 – DATA 1 output setting; or
  • Page 16 – DATA 2 output setting; Figure 5-4 DATA 2 OUTPUT SETUP menu; DATA 3 output setting; Selection of NMEA0183 or log pulse
  • Page 17 – Setting DATA 4 to Data Output
  • Page 19 – Setting DATA 4 to DGPS
  • Page 20 – DGPS; Beacon Receiver Set GR-80; Signal level
  • Page 21 – TAPING ANTENNA UNIT GPA-018S; the last wind of butyl tape and then back to the base.; ) Squeeze edges of tape with thumb and index finger.
  • Page 24 – 工事材料表; 工事材料表; Antenna Cable Set
Loading the manual

INSTALLATION MANUAL

GPS NAVIGATOR

GP-90

1. EQUIPMENT LIST ............................................................................................ 1

2. DISPLAY UNIT .................................................................................................. 2

3. ANTENNA UNIT ................................................................................................ 3

4. WIRING ............................................................................................................. 5

5. INITIAL SETTINGS ........................................................................................... 7

6. OPTIONAL DGPS ........................................................................................... 18

7. TAPING ANTENNA UNIT GPA-018S ............................................................. 19

PACKING LISTS & INSTALLATION MATERIALS ........................................... A-1

OUTLINE DRAWINGS ...................................................................................... D-1

INTERCONNECTION DIAGRAM ......................................................................S-1

Back

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - SAFETY INSTRUCTIONS; WARNING; Use the correct fuse.; CAUTION

SAFETY INSTRUCTIONS WARNING Do not work inside the equipment unless totally familiar with electrical circuits. Hazardous voltage which can cause electrical shock, burn or serious injury exists inside the equipment. Turn off the power at the mains switchboard before beginning the installation.Post a ...

Page 3 - LIST; Standards; For DGPS; Options

1 1. EQUIPMENT LIST Standards Name Type Q'ty Mass (kg) Remarks GPA-017S GPA-018S Antenna Unit GPA-019S 1 For DGPS GP-90-N Without Beacon RX Display Unit GP-90-A 1 2.2 With Beacon RX CP20-01900 With Antenna Cable Installation Materials CP20-01950 1 set See lists at end of manual. Without Antenna Cabl...

Page 4 - UNIT; Locate the unit away from exhaust pipes and vents.; Table Top and Overhead Mounting; Display unit mounting methods; Flush mounting type F; Flush mounting type S; Name Type

2 2. DISPLAY UNIT The display unit can be installed with either of four methods as shown below. Refer to the outline drawing at the end of manual. • Locate the unit away from exhaust pipes and vents. • The mounting location should be well ventilated. • Mount the unit where shock and vibration are mi...

Other Furuno Models

All Furuno Other