Fujitsu FPCCC48 - Manual
Fujitsu FPCCC48 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installing the Tablet PC in the HEC
- Page 3 – Bumper
- Page 4 – To ensure good adhesion, clean the exterior surface of
- Page 5 – Additional HEC Information; You can also use one of the D-rings to attach a pen tether.; Caring for the HEC
These instructions provide details on using the FPCCC48
Harsh Environment Case (HEC). This HEC is designed for
use with your Stylistic ST5000 Tablet PC. The HEC provides
maximum protection against water, dust, and other hazards
when transporting, using, or storing your Tablet PC.
We strongly recommend that you read these instructions
prior to using the HEC with your computer.
Note the following when using the HEC:
• To avoid overheating, suspend the Tablet PC when
charging the battery pack while the system is in the case
and not in use.
• To prevent scratches, a screen protector should be
installed on the display window of the HEC. Two screen
protectors are provided with the HEC. Additional screen
protectors can be obtained from your reseller, or from
the Fujitsu Web site at: us.fujitsu.com/computers.
• If you use the Tablet PC both with and without the HEC,
a screen protector can be left in place on the system. If
the system will be used only in the HEC, remove the
screen protector from the system for better viewing.
I N S T R U C T I O N S
Harsh Environment Case
User’s Guide
FPCCC48
F u j i t s u C o m p u t e r S y s t e m s
FPC58-1045-01 HEC.fm Page 1 Friday, December 19, 2003 1:09 PM
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 • If you use a pen tether, attach it to one of the D-rings on the back of the case. Figure 1. Tablet PC HEC - Front Installing the Tablet PC in the HEC To install your Tablet PC into the HEC, position the case horizontally as shown in Figure 2. Unzip the long zipper that runs along two sides of th...
3 Figure 2. Opening the Tablet PC HEC If you are using a system with a standard battery installed, leave in place the foam bumper that is attached with a Velcro strip on the inside of the case (see Figure 2 for location). If you are using a system with a high-capacity battery installed, remove the f...
4 Figure 3. Tablet PC HEC - Top Installing a PC Card, Memory Stick™, or SD Card To install a PC Card, Memory Stick, or SD card while the system is installed in the HEC, unzip the short zipper located on the top edge of the HEC to gain access to the slots (See Figure 3). After you have installed the ...
