Flymo 1000XT - Manual

Flymo 1000XT

Flymo 1000XT – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
Page: / 9

Table of Contents:

  • Page 2 – Carton Contents; Safety; General
  • Page 3 – Cables
  • Page 4 – Safety Guard Assembly; Assembly Instructions
  • Page 5 – • BEFORE USE; switch lever; Cut with nylon line at an angle using the tip.; Use; AUTO; line cutter; Cable Restraint
  • Page 6 – Cutting Head; To replace nylon line.
  • Page 7 – Maintenance; • WARNING
  • Page 8 – Fault Finding Chart; FAULT; Yes; Environmental Information
  • Page 9 – EC Declaration of Conformity
Loading the manual

IMPOR

TANT INFORMA

TION

Read before use

& retain for future reference

For all customer enquiries or for replacement parts, contact:-

0870 609 1901

www.flymo.com

[email protected]

SAMURAI 1000XT

AUTO-

MATIC SPEED

CONTROL FOR

YOUR SAFETY AND

COMFORT

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Carton Contents; Safety; General

Carton Contents IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna Outdoor Products Customer Service Department direct:-Telephone : 0870 609 1901 Fax : 0870 609 1902 Safety General 1. Never allow chil...

Page 3 - Cables

3. Do not use the product if the electric cables are damaged or worn. 4. Immediately disconnect from the mains electricity sup- ply if the cable is cut, or the insulation is damaged.Do not touch the electric cable until the electrical sup-ply has been disconnected. Do not repair a cut ordamaged cabl...

Page 4 - Safety Guard Assembly; Assembly Instructions

Switch Handle and Handle Tube Assembly (A),(B) & (C) 1. Loosen the four bolts on the Handle Clamp (A) . 2. Insert the Switch Handle and the Steady Handle into the holes at the side of the HandleClamp (B1 Right Handed) (B2 Left Handed) - using the Hex Drive Tool to turn theswitch handle (B3) 3. A...

Other Flymo Models

All Flymo Other