Flymo 1000XT - Manuals - manualsarea.com

Page 2 - Carton Contents; Safety; General

Carton Contents IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna Outdoor Products Customer Service Department direct:-Telephone : 0870 609 1901 Fax : 0870 609 1902 Safety General 1. Never allow chil...

Page 3 - Cables

3. Do not use the product if the electric cables are damaged or worn. 4. Immediately disconnect from the mains electricity sup- ply if the cable is cut, or the insulation is damaged.Do not touch the electric cable until the electrical sup-ply has been disconnected. Do not repair a cut ordamaged cabl...

Page 4 - Safety Guard Assembly; Assembly Instructions

Switch Handle and Handle Tube Assembly (A),(B) & (C) 1. Loosen the four bolts on the Handle Clamp (A) . 2. Insert the Switch Handle and the Steady Handle into the holes at the side of the HandleClamp (B1 Right Handed) (B2 Left Handed) - using the Hex Drive Tool to turn theswitch handle (B3) 3. A...

Page 5 - • BEFORE USE; switch lever; Cut with nylon line at an angle using the tip.; Use; AUTO; line cutter; Cable Restraint

J1 J2 Assembly Instructions cont’ Line Feed • WARNING• Wear eye protection. Do not lean over the trimmer whilst trimming,objects may be thrown by the cutting line.Do not allow cutting head to rest on the ground.Do not overload your trimmer.Overloading can be avoided by making surethe motor speed doe...

Page 6 - Cutting Head; To replace nylon line.

Cutting Head To replace nylon line. For your convenience it is recommended you buyspool and line complete. Nylon line only is alsoavailable. Both are available from HusqvarnaOutdoor Products stockists. To fit spool and line complete: 1. Remove the Cap (Q1) and Spool Holder (Q2) 2. Remove old spool. ...

Page 7 - Maintenance; • WARNING

Maintenance X W • WARNING Disconnect from the mains electricity sup-ply, before attempting any maintenance oradjustment. Cutting head continues torotate after the trimmer has beenswitched off. Keep fingers and handsclear of the line cutter on leading edge ofguard. Caring for your Product 1. Disconne...

Page 8 - Fault Finding Chart; FAULT; Yes; Environmental Information

Fault Finding Chart WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment. FAULT CHECK ACTION Is the line fed out and visible?Has line been removed fromcleat? Remove cap and spool, free lineand re-fit spool and cap. SEE “CUTTING HEAD” The line may be ja...

Page 9 - EC Declaration of Conformity

5107683-02 Husqvarna Outdoor Products Aycliffe Industrial Park NEWTON AYCLIFFE Co.Durham DL5 6UP ENGLAND Telephone - 0870 609 1901 Fax - 0870 609 1902 Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice. Newton Aycliffe,...