Epson CFS-900P- Manual
Epson CFS-900P– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – We will tell you later when to; Step 3 – Install Tube Supports; This photo was taken after the tubes were installed.
- Page 3 – Step 4 - Install Protective Velcro; The ends of; Empty Carts
- Page 4 – Step 7 – Finish Tubing Installation
- Page 5 – is there and that it is not blocked or; front to back
- Page 6 – Velcro attaches bottles to printer
- Page 7 – Turn on the power; on the front of the; do not lift them up; . Lifting up the cartridges lets air into
MIS Continuous Flow for Epson Photo 900
Installation Instructions
What you will need to Install the Photo 900 CFS
•
Complete CFS-900P Kit
•
Scissors
•
Measuring Tape or Ruler
•
Marking Pen or Pencil
•
Paper Towels
•
Alcohol or Cleaning Solution
What is included in your Photo 900 CFS Kit
•
Cartridge Set with tubes attached
•
Set of 6 Inks (C, Lc, M, Lm, Y, K)
•
6 Drilled Bottle Caps
•
Clear Plastic Bridge Bracket with Black Velcro
•
Clear Plastic Tube Support with White Adhesive Backing
•
1 Beige Tube Clip
•
6 Black Velcro Circles (Hook & Loop)
•
1 Piece of Loop Velcro ¾ x ¾
•
2 thin tie wraps.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Epson CFS-900P
Summary
Step 1 - Check Printer Condition If you have a brand new printer, follow the Epson instructions for setting up your printer. Use the Epson cartridges that came with the printer. Follow normal installation instructions for the software. Test the printer by printing pictures. Learn how to use the Epso...
Bracket. Do not separate the Hook and Loop, Keep them together just like they were when delivered. Remove the adhesive backing from the Hook portion of the Velcro. Keep it attached to the Loop portion. Carefully install the Bridge Bracket in its proper location at the left edge of the housing, as sh...
Step 6 – Install Cartridges Use a flat blade screwdriver and remove the Epson cartridge hold down clamps, black and color. Insert the screwdriver blade at the hinge point and twist. The clamps will come right off, without any damage. Keep these in a safe place, you may need them in the future. Remov...
