Enviro 50-029 - Manual

Enviro 50-029

Enviro 50-029 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
Page: / 33

Table of Contents:

  • Page 2 – Safety Precautions
  • Page 3 – Table of Contents
  • Page 4 – Codes And Approvals; IN CANADA
  • Page 5 – Specifications; inches; Must have hearth pad if installed on a carpeted surface.; If this unit is installed in an alcove the alcove must meet
  • Page 6 – Operating Instructions; FOR YOUR SAFETY READ COMPLETELY BEFORE OPERATING.; If not recently done, remove the glass and let the unit air out; Turn on gas to the heater. Leak test all joints; NEVER USE AN OPEN FLAME FOR LEAK TESTING.; the rocker switch to ON. Check that all burner ports have flame.
  • Page 7 – Maintenance And Service; When the fireplace has cooled; , remove the face of the fireplace along with the glass. See; Use a mild glass cleaner and a soft cloth; Depending on the amount of use,; Do not clean the glass; as in the
  • Page 8 – replacement is required (see; ). Wear gloves when handling damaged glass door; must; be done by a licensed or; The glass must be purchased from an ENVIRO dealer. No substitute; the tape in a bottom corner. Close door.
  • Page 9 – TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY; on how to remove and install the HI/LO regulator.
  • Page 10 – NOTE: Venting terminals shall not be recessed into walls or siding.; Initial Installation; QUALIFIED INSTALLERS ONLY; D E
  • Page 11 – FOR THE VENT TERMINATION CAN BE ACCOMMODATED.; FOLLOW THE VENT LENGTH DIAGRAM
  • Page 15 – black
  • Page 16 – should have a 1⁄4 inch rise
  • Page 17 – STEP 4
  • Page 18 – support straps that extend out beyond the edge of the flashing.; Roof Pitch; the flashing and the roof. Insure the roofing
  • Page 21 – AUTOMATIC SAFETY SHUT DOWN:
  • Page 23 – Always check for gas leaks with a soap
  • Page 25 – Secondary Installation; NOTE: The logs are fragile and
  • Page 26 – CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED.; ALL
  • Page 27 – Trouble Shooting; Problem
  • Page 28 – Parts List; Reference
  • Page 31 – Parts Diagram; SC
  • Page 32 – Warranty; AN OFFICIAL WARRANTY CLAIM FORM:
  • Page 33 – Installation Data Sheet; INSTALLER’S SIGNATURE:
Loading the manual

SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED PAPER.

B Y : S H E R W O O D I N D U S T R I E S L T D

OWNER’S MANUAL

PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE

This appliance may be installed in an after market

permanently located, manufactured (mobile) home,

where not prohibited by local codes.

This appliance is only for use with the type of gas

indicated on the rating plate. This appliance is

not convertible for use with other gases, unless a

certified kit is used.

WHAT TO DO IF YOU SMELL GAS

• Open windows/Extinguish any open flame.

• Do not try to light any appliance.

• Do not touch any electrical switch or use any

phone in your building.

• Immediately call your gas supplier from a

neighbour’s phone. Follow the gas supplier’s

instructions.

• If you cannot reach your gas supplier, call the

fire department.

WARNING

If the information in this manual

is not followed exactly, a fire or

explosion may result causing property

damage, personal injury or loss of

life. Installation and service must be

performed by a qualified installer,

service agency or the gas supplier.

FOR YOUR SAFETY: Do not store or use gasoline or other Flammable vapours and liquids in

the vicinity of this or any other appliance.

50-029

Massachusetts installations (Warning): This product must be installed by a licensed

plumber or gas fitter when installed within the Commonwealth of Massachusetts. Other

Massachusetts code requirements:-Flexible connector must not be longer than 36

inches, shut off valve must be a “T” handle gas cock, only direct vent sealed combustion

products are approved for bedroom/bathrooms, fireplace dampers must be removed or

welded in the open position prior to the installation of a fireplace insert or gas log.

ASCOT

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Safety Precautions

2 FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVIRO” HEATER, PLEASE CAREFULLY READ THE FOLLOWING INFORMATION: • All ENVIRO gas-fired appliances must be installed in accordance with their instructions. Carefully read all the instructions in this manual first. Consult the building authority having j...

Page 3 - Table of Contents

3 Safety Precautions....................................................................................................2Table of Contents......................................................................................................3Codes And Approvals...........................................

Page 4 - Codes And Approvals; IN CANADA

4 DIRECT VENT ONLY: This type is identified by the sufix DV. This appliance draws all of its air for combustion from outside the dwelling, through a specially designed vent pipe system. ** TOP VENT DV ONLY** This appliance has been tested and approved for installations from 0 feet to 4500 feet (1372...

Other Enviro Models

All Enviro Other