Enviro Ascot - Manual

Enviro Ascot

Enviro Ascot – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
Page: / 40

Table of Contents:

  • Page 2 – Safety Precautions
  • Page 3 – Table of Contents
  • Page 4 – Codes And Approvals; IN CANADA
  • Page 5 – Specifications; inches
  • Page 6 – Operating Instructions; FOR YOUR SAFETY READ COMPLETELY BEFORE OPERATING.; furnit ure, gasoline or o ther flammable vapors away.; TO TURN OFF GAS TO APPLIANCE; LIGHTING INSTRUCTIONS
  • Page 7 – Component; For Your Safety, Read Safety Precautions And; If not recently done, remove the glass and let the unit air out; Turn on gas to the heater. Leak test all joints; NEVER USE AN OPEN FLAME FOR LEAK TESTING.
  • Page 8 – Maintenance And Service; When the fireplace has cooled; , remove the face of the fireplace along with the glass. See; Use a mild glass cleaner and a soft cloth; Depending on the amount of use,; Do not clean the glass; as in the; If the unit does not spark when lighting, the battery in the
  • Page 9 – must; be done by a licensed or; The glass must be purchased from an ENVIRO dealer. No substitute
  • Page 10 – threads before installing into the brass elbow.; TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY; instructions supplied with the kit.; Remove the glass as shown in the
  • Page 12 – Initial Installation; QUALIFIED INSTALLERS ONLY; Note: Must have hearth pad if installed on a
  • Page 13 – Refer to
  • Page 14 – D E; NOTE: Venting terminals shall not be recessed into walls or siding.
  • Page 15 – INSTALLATION INSTRUCTIONS:
  • Page 16 – Manufacturer
  • Page 17 – Intertek WH listing of the appliance.
  • Page 18 – Refer to Figure 20 to determine were the vent restrictor should be
  • Page 19 – location of the appliance.
  • Page 20 – black
  • Page 21 – should have a 1⁄4” rise
  • Page 23 – Roof Pitch
  • Page 27 – AUTOMATIC SAFETY SHUT DOWN:
  • Page 29 – Always check for gas leaks with a soap
  • Page 31 – Secondary Installation; NOTE: The logs are
  • Page 32 – ALL
  • Page 33 – CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED.
  • Page 34 – Trouble Shooting
  • Page 35 – Parts List; Reference
  • Page 38 – Parts Diagram; SC
  • Page 39 – Warranty; AN OFFICIAL WARRANTY CLAIM FORM:
  • Page 40 – Installation Data Sheet; INSTALLER’S SIGNATURE:
Loading the manual

SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED PAPER.

B Y : S H E R W O O D I N D U S T R I E S L T D

OWNER’S MANUAL

PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE

50-029

ASCOT

This appliance may be installed in an after-market

permanently located, manufactured (mobile)

home, where not prohibited by local codes.

This appliance is only for use with the type of gas

indicated on the rating plate. This appliance is

not convertible for use with other gases, unless a

certified kit is used.

WHAT TO DO IF YOU SMELL GAS

• Open windows/extinguish any open

flame.

• Do not try to light any appliance.

• Do not touch any electrical switch or

use any phone in your building.

• Immediately call your gas supplier

from a neighbour’s phone. Follow the

gas supplier’s instructions.

• If you cannot reach your gas supplier,

call the fire department.

WARNING

If the information in this manual

is not followed exactly, a fire or

explosion may result causing property

damage, personal injury or loss of

life. Installation and service must be

performed by a qualified installer,

service agency or the gas supplier.

FOR YOUR SAFETY

Do not store or use gasoline or other

flammable vapours and liquids in the

vicinity of this or any other appliance.

Massachusetts installations (Warning): This product must be installed by a licensed

plumber or gas fitter when installed within the Commonwealth of Massachusetts.

Other Massachusetts code requirements: Flexible connector must not be longer than

36in., a shut off valve must be installed; only direct vent sealed combustion products

are approved for bedrooms/bathrooms. A carbon monoxide detector is required in all

rooms containing gas fired direct vent appliances.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Safety Precautions

2 FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVIRO” HEATER, PLEASE CAREFULLY READ THE FOLLOWING INFORMATION: • All ENVIRO gas-fired appliances must be installed in accordance with their instructions. Carefully read all the instructions in this manual first. Consult the building authority having j...

Page 3 - Table of Contents

3 Safety Precautions....................................................................................................2Table of Contents......................................................................................................3Codes And Approvals...........................................

Page 4 - Codes And Approvals; IN CANADA

4 DIRECT VENT ONLY: This type is identified by the suffix DV. This appliance draws all of its air for combustion from outside the dwelling, through a specially designed vent pipe system. ** TOP VENT DV ONLY** This appliance has been tested and approved for installations from 0 feet to 4500 feet (137...

Other Enviro Models

All Enviro Other