Dual XPA4100 - Manual - manualsarea.com

Page 2 - Preparation; TYPICAL MOUNTING METHOD

2 XPA SERIES INSTALLATION Preparation Please read entire manual before installation. Due to the technical nature of amplifiers, it is highly recommended that your DUAL amplifier is installed by a professional installer or an authorized dealer. Before You Start • Disconnect negative battery termina...

Page 3 - XPA SERIES; Connection Descriptions

NOTEBe sure to follow specific instructions included with your amplifier installation kit(not included with this amplifier). The information below should be used a general guideline only. Power Wire (+12V) • Disconnect negative battery terminal before proceeding. Consult a qualified technician for i...

Page 4 - Power and Speaker Connections

4 XPA SERIES INSTALLATION Power and Speaker Connections Speaker Connection(s) Ground Connection Remote Connection 123 +12VDC Battery Connection Fuse(s) 45 1 2 3 4 5 4 3 2 5 1 4 3 2 5 1 XPA2100 XPA4100 XPA6100

Page 5 - Audio Inputs and Controls

5 XPA SERIES INSTALLATION Audio Inputs and Controls LED Indicator Bass Boost Crossover Mode Switch Crossover Frequency 1234 Input Level Control High Level Inputs Low Level Inputs Input Mode Switch 5678 1 2 3 4 5 6 7 1 2 4 5 6 7 1 2 3 4 5 8 6 7 7 XPA2100 XPA4100 XPA6100

Page 6 - Main Power Connections; Typical Wire Routing

6 XPA SERIES INSTALLATION Fuse Rating When replacing fuses, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the amplifier. XPA2100 25 amp ATO x 1 XPA4100 25 amp ATO x 2 XPA6100 20 amp ATO x 2 Power/Ground Wire Size For optimum performance, use only the wire...

Page 7 - Amplifier Connections; Speaker Connections

7 XPA SERIES INSTALLATION Amplifier Connections Speaker Connections Connect speaker wires observing polarity. The minimum impedance load for the XPA2100 and XPA4100is 2 ohms stereo and 4 ohms bridged. The minimum impedance load for the XPA6100 is 2 ohms. Use of loads lower than these is not recomme...

Page 9 - Limited One-Year Warranty

9 XPA SERIES WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of o...

Page 10 - Specifications

10 XPA SERIES OPERATION Specifications CEA-2006 Power Standard Specifications (reference: 14.4VDC, 20Hz~20kHz) Power Output: 50 Watts RMS x 2 channels at 4 ohms and < 1% THD+N Signal to noise ratio: 75dBA (reference: 1 watt into 4 ohms) Additional power output: 75 Watts RMS x 2 channels at 2 ...

Page 12 - Troubleshooting

Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2008 Dual Electronics Corp. NSA0208-V02 XPA SERIES OPERATION Troubleshooting Problem Cause Action Unit will not turn on (no power LED indicator) +12V wire not connected or incorrect voltage REM wire not connected or incorrect voltage ...

Dual XPA4100 - Manual

Table of Contents:

Summary

Other Dual Models