Dual MXD40 - Manual - manualsarea.com

Page 2 - INSTALLATION; Preparation

2 MXD40 INSTALLATION Preparation Please read entire manual before installation. Before You Start• Disconnect negative battery terminal. (consult a qualified technician for instructions)• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where ...

Page 3 - Wiring Diagram

AMP Remote Turn-On Connect to amplifier or powerantenna. Insulate wire if not used. RCA Cable (sold separately) BLUE Antenna Connector Rear Preamp Output Connect to amplifier RCA Input GRAY Ground Connect to chassis ground. BLACK Accessory Connect to existing ignitioncircuit or switched 12 volt sour...

Page 4 - OPERATION; Control Locations; MARINE

4 MXD40 OPERATION Control Locations Release Volume Tune/Track Up Band Bass Boost Eject Display Play/Pause Auto Store/Preset Scan 1 2 3 4 5 6 7 8 9 Preset 6 Preset 5 Preset 4/CD Random Preset 3/CD Repeat Preset 2/CD Intro Preset 1/CD Top Audio Power Tune/Track Down 10 11 12 13 14 15 16 17 18 17 16 15...

Page 5 - General Operation

General Operation 5 MXD40 OPERATION Press REL and pull away from the left side to remove. To re-install, insert right side of faceplate first then push leftside to secure. *For semi-permanent faceplate installation, remove trim ring and installsupplied Phillips head #1 screw through left side of mou...

Page 7 - Tuner Operation

7 MXD40 OPERATION Tuner Operation Press TUNE or momentarily to seek the next strong station. Press TUNE or for more than 2 seconds, then press TUNE or momentarily to move radio frequency up or down one step at a time. Press and hold toadvance quickly. If tuning is not adjusted for 2 seconds, theunit...

Page 8 - CD Player Operation

8 MXD40 OPERATION CD Player Operation With the label facing up, insert a standard 5" CD into the CDslot. The CD will automatically begin playback. Press the EJECT button to stop and eject the CD. The unit will change to tuner mode. Press TRACK to skip to the beginning of the next track. Press TR...

Page 9 - WARRANTY; Limited One-Year Warranty

9 MXD40 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary fromstate to state. Namsung America Inc. warrants this product tothe original purchaser to be free from defects inmaterial and workmanship, under normalconditions, for ...

Page 10 - Specifications

10 MXD40 OPERATION Specifications Signal-to-noise: >86dB Frequency response: 20Hz-20kHz, ±3dB Channel separation @ 1kHz: >65dB D/A converter: 16 Bit Tuning range: 87.5MHz-107.9MHz FM mono sensitivity: 12dBf 50dB quieting sensitivity (stereo): 16dBf Stereo separation @ 1kHz: 40dB Frequency resp...

Page 11 - Troubleshooting

MXD40 OPERATION Troubleshooting 11 Problem Cause Action Yellow wire not connected or incorrect voltageRed wire not connected or incorrect voltage Check connections for proper voltage(11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Speaker wires not connected Che...

Page 13 - INSTALLATION/OWNERS MANUAL

INSTALLATION/OWNERS MANUAL 6.5" Dual Cone Marine Speakers DMP65 MARINE

Page 14 - Preparation/Installation

2 DMP65 INSTALLATION Preparation/Installation Please read entire manual before installation. Before You Start• Disconnect negative battery terminal. (consult a qualified technician for instructions) • Use extreme caution when drilling holes to avoid damaging fuel lines, hydraulic lines or existing w...

Page 16 - SPECIFICATIONS

7.13" 2.5" .88" 5.13" 45Hz-18kHz, ±3dB 90dB 1W/1M 4 ohms 20 Watts 60 Watts Specifications subject to change withoutnotice Outside Diameter Mounting Depth Mounting Height Cut-out Diameter Frequency Response Sensitivity Impedance RMS Power Peak Power Namsung America Inc. 21318 64th Ave...

Dual MXD40 - Manual

Table of Contents:

Summary

Other Dual Models