Page 2 - INSTALLATION; TYPICAL MOUNTING METHOD; Preparation
2 MDM300 INSTALLATION TYPICAL MOUNTING METHOD REMOVAL KEYS MOUNTING SLEEVE Preparation Please read entire manual before installation. Before You Start• Disconnect negative battery terminal. Consult a qualified technician for instructions.• Avoid installing the unit where it would be subject to high...
Page 3 - Wiring Diagram; FUSE
3 MDM300 INSTALLATION Wiring Diagram FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The MDM300 uses one 10 amp AGC fuse located in-line.
Page 4 - OPERATION; Control Locations - Receiver
4 MDM300 OPERATION Control Locations - Receiver Preset 4 / Random Preset 3 / Repeat Preset 2 / Intro Preset 1 / Play / Pause Local / Distance Mono / Stereo Tune / Track Up Band Mode Power Tune / Track Down Release Mute AMS Scan Display Audio / Volume Knob Loudness Eject USB Input Auxiliary Input P...
Page 5 - Control Locations - Remote
5 MDM300 OPERATION Control Locations - Remote Mute Preset 6 / +10 Preset 5 / -10 Preset 4 / Random Preset 2 / Intro Preset 1 / Play / Pause Mode Band Tune / Track Down Power Volume Up Select Tune / Track Up Volume Down Scan Display Loudness Preset 3 / Repeat 1 2 3 5 6 7 8 9 10 1 10 2 11 3 12 4 13 5...
Page 6 - General Operation
6 MDM300 OPERATION Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Press or any other button (except EJECT) to turn the unit on. Press to turn the unit off. Press MODE to select between AM/FM, CD player, au...
Page 7 - General Operation - Setup Menu
7 MDM300 OPERATION General Operation - Setup Menu Menu Function Options Action Equalizer DSP Toggles between the following equalization options: OFF, POP, ROCK, CLASS and FLAT). Beep Confirmation BEEP OFF Disables the confirmation beep. BEEP ON Enables the confirmation beep. Seek Priority SEEK 1 E...
Page 9 - ll; AM/FM Tuner Operation
9 MDM300 OPERATION Seek Tuning Manual Tuning Scan Tuning Band Storing and Recalling Station Presets Automatically Store Stations Preset Scan Distance Tuning Stereo / Mono Press TUNE nn or TUNE ll momentarily to seek to the next strong station. Press and hold TUNE nn or TUNE ll until "MANUA...
Page 10 - CD Player Operation
10 MDM300 OPERATION Insert CD Eject CD Track Select Fast Forward/Reverse Pause Intro Repeat Random CD-R/CD-RW Compatibility With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Press EJECT to eject the CD. The unit will change to previous ...
Page 14 - SD Card / USB Operation
14 MDM300 OPERATION SD Card / USB Operation To play MP3/WMA files from most USB mass storage devices, line up the USB connector and insert the USB device into the USB port. To play MP3/WMA files from an SD Card, insert the card horizontally with the label facing up into the SD Card slot located be...
Page 18 - Limited One Year Warranty; Who is covered? This warranty is extended
18 MDM300 OPERATION Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one ...
Page 19 - Troubleshooting
19 MDM300 OPERATION Troubleshooting Problem Cause Action Unit will not turn on (no power) Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Repla...
Page 20 - Specifications; CEA-2006 Power Standard Specifications
20 MDM300 OPERATION Specifications Frequency response: 20Hz-20kHz Channel separation @ 1kHz: >60dB D/A converter: 1 Bit Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: >30dB Frequency response: 30Hz-13kHz Tuning range: 530kH...
Page 21 - FCC Compliance
21 MDM300 OPERATION FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired...
Page 22 - Notes
Page 26 - Preparation/Installation
2 DMP67 INSTALLATION Preparation/Installation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions.• Use extreme caution when drilling holes to avoid damaging fuel lines, hydraulic lines or existing w...
Page 27 - WARRANTY
3 DMP67 WARRANTY Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one yea...
Page 28 - SPECIFICATIONS
7.13" 2.13" .87" 5.13" 45Hz-15kHz 88dB 1W/1M 4 ohms 20 Watts @ 1kHz 100 Watts @ 1kHz Design and specifications subject to change without notice. Outside Diameter Mounting Depth Mounting Height Cut-out Diameter Frequency Response Sensitivity Impedance RMS Power Peak Power DMP67 SPEC...
