Dual XDM7610 - Manual - manualsarea.com

Page 2 - INSTALLATION; Preparation

2 TYPICAL FRONT-LOAD DIN MOUNTING METHOD Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions.• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, o...

Page 3 - Wiring Diagram

3 FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XDM7610 uses one10 amp ATM fuse located beside the wiring connector. XDM7610 INSTALLATION Wiring Diagram

Page 4 - OPERATION; Control Locations - Receiver

4 Tune/Track Down Mode/Search Tune/Track Up Preset #2/Repeat Preset #1/Folder Down Open Volume Eject Preset #6/Folder Up *Key #7 EQ Audio/Setup Display 123456789 10 Mute Tuner Scan/*Key #8 *Key #9 *Key #0 Band/Play/Pause Infrared Sensor Power Preset #5 Preset #4/Intro Preset #3/Random Reset AS/PS/En...

Page 5 - Control Locations - Remote

5 XDM7610 OPERATION Control Locations - Remote EQ Open Display Preset #5 Preset #4/Intro Preset #1/Folder Down Mode/Search Tune/Track Down Band/Play/Pause 12345678 9 10 111213141516171819 1 2 4 3 6 5 8 17 9 10 11 12 14 13 15 16 7 18 19 Power Volume Up AS/PS/Enter Audio/Setup Tune/Track Up Mute Volum...

Page 6 - General Operation

6 The front panel is semi-permanently attached during assembly. Please refer to the separate yellow instructions (before installation) to make the front panel removable. With the unit off, press OPEN to allow the front panel to slide down. Gently squeeze the release tab located on the bottom center ...

Page 7 - General Operation - Setup Menu

7 XDM7610 OPERATION General Operation - Setup Menu Menu Function Options Action Loudness Curve LOUD OFF Disables the loudness function. LOUD ON Enables the loudness function. Activating this feature will enhance the bass and treble frequencies when listening to music at low volumes. Clock Display Pr...

Page 8 - General Operation - Audio Settings

8 Press AUDIO momentarily to select between Volume (default), Bass, Treble, Balance, Fader & Subwoofer. Press AUDIO until BAS appears then rotate encoder left/right to adjust ( -6 minimum / +6 maximum). Press AUDIO until TRE appears then rotate encoder left/right to adjust ( -6 minimum / +6 maxi...

Page 9 - Tuner Operation

9 Seek Tuning Manual Tuning Scan Tuning Band Storing and Recalling Station Presets Automatically Store Stations Preset Scan Press TUNE nn or TUNE ll momentarily to seek the next strong station. Press TUNE nn or TUNE ll for more than 2 seconds, then release. "MANUAL" will momentarily appear i...

Page 10 - CD Player Operation

10 Insert CD Eject CD Track Select Fast Forward and Reverse Pause Intro Repeat Random CD-R/CD-RW Compatibility With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Press EJECT to eject the CD. The unit will change to previous mode of operati...

Page 12 - MP3/WMA Button Function Table

12 XDM7610 OPERATION CD Player Operation - MP3/WMA Files Press SEARCH for more than 3 seconds, to select between the following modes:• Direct File Select• Alphanumeric File or Folder Search• File or Folder Navigate Press SEARCH for more than 3 seconds, then release. “MP3 T * " or “WMA T * ” will...

Page 17 - WARRANTY; Limited One Year Warranty

17 XDM7610 WARRANTY Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one y...

Page 18 - Specifications

18 XDM7610 OPERATION Specifications Frequency response: 10Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 1 Bit Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz Tuning range: 530kHz-17...

Page 19 - Troubleshooting

19 Problem Cause Action Unit will not turn on (no power) Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Unit has power (but no sound...

Dual XDM7610 - Manual

Table of Contents:

Summary

Other Dual Models