Delta DP200 - Manual

6 DRILL PRESS PARTS Fig. 2 1 - Drill Press Head and Motor 2 - Table Raising and Lowering Handle 3 - Table Clamp 4 - Chuck 5 - Chuck Key 6 - Pinon Shaft Handles (3) 7 - M8x1.25x125mm Carriage Head Screws (2), M8 FlatWashers (2), M8.1 Lock Washers (2), M8x1.25 Hex Nuts(2) (for fastening the base to a ...

7 ASSEMBLY WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTIONMANUAL. 1. Assemble the column (A) Fig. 3, to the base (B) using the four screws, three of which are shown at (C). Loose...

10 Fig. 15 Fig. 16 R Q S T 10. IMPORTANT: Make certain the spindle taper (Q) Fig. 15, and tapered hole in chuck (R) are clean and free ofany grease, lacquer or rust preventive coatings. NOTE: Household oven cleaner can effectively remove any sub-stance from the spindle and chuck; however, carefullyf...

11 LOCKING SWITCH IN THE “OFF” POSITION IMPORTANT: When the machine is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use. This can be done by grasping theswitch toggle (B) and pulling it out of the switch, asshown in Fig. 19. With the switch toggle (B) removed...

12 Fig. 22 Fig. 23 Fig. 24 3. The table can be tilted right or left by pulling out and removing table alignment pin (C) Fig. 22. NOTE: If pin (C) is difficult to remove, turn nut (E) clockwise to pull pinout of casting. 4. Fig. 23, illustrates the table alignment pin (C) removed. Loosen table lockin...

13 Fig. 27 DRILLING HOLES TO DEPTH Where a number of holes are to be drilled to exactly thesame depth, a depth stop is provided in the pinion shafthousing and is used as follows: 1. DISCONNECT MACHINE FROM POWER SOURCE. 2. Insert bit into chuck. 3. Lower the spindle until the pointer (C) Fig. 27, li...

14 OPERATION Your drill press is to be used with drill bits with a shank of 1/2" or less in diameter. The following will give the inexperiencedoperator a start on common drill press operations. Use scrap material for practice to get a feel of the machine beforeattempting regular work. WARNING: T...

Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin normal use has proven to be defective in workmanship or material, provided that the customer returns the productprepaid to a Delta factory service c...