Dell PowerEdge M610 Quick Guide

Page 3 - Installation And Configuration; Unpacking The System; Installing The Rails And Enclosure; Installing A Sleeve In The Enclosure

Installation And Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the blade server or enclosure. Unpacking The System Unpack your blade server or enclosure and identify each item. Installing The Rails And Enclosure Figure 1. Installing t...

Page 4 - Installing A Quarter-Height Blade In A Sleeve; Installing A Full Or Half-Height Blade

Figure 2. Installing a Sleeve NOTE: Before you install or remove a sleeve from the enclosure, ensure that the top slot of the sleeve (Blade a) is empty. You can install a blade in the top slot (Blade a) after you install the sleeve in the enclosure. Remove the orange cover from the sleeve handle. Sl...

Page 5 - Connecting The CMC And iKVM Modules

Figure 4. Installing a Half-Height Blade NOTE: The above figure shows installation of a half-height blade. The procedure for installing a full-height blade is identical to installing a half-height blade. Beginning at the top, slide the blades into the enclosure from left to right. When the blade is ...

Page 6 - Connecting The System To Power; Turning On The Enclosure

Connecting The System To Power Figure 6. Connecting Power to the System Connect the system’s power cables to the system power supplies. CAUTION: To prevent the power cables from being disconnected accidentally, use the plastic clip on each power supply to secure the power cable to the power supply, ...

Page 7 - Turning On The Blades; Complete The Operating System Setup

Turning On The Blades Figure 8. Turning on a Blade Press the power button on each blade, or power on the blades using the systems management software. Complete The Operating System Setup If you purchased a preinstalled operating system, see the documentation associated with the operating system. To ...

Page 8 - Obtaining Technical Assistance; NOM Information

NOTE: Always check for updates on support.dell.com/manuals and read the updates first because they often supersede information in other documents. Obtaining Technical Assistance If you do not understand a procedure in this guide or if the system does not perform as expected, see your Owner’s Manual....

Page 9 - Technical Specifications

Technical Specifications NOTE: For additional specifications, see your system Owner's Manual. Power — Blades Coin-cell battery 3 V CR2032 Lithium coin cell Power — Enclosure AC/DC power supply (per power supply module) Wattage 2360 W and 2700 W Connector IEC C20 Heat dissipation 1205 BTU/hr (maximum...