Datalogic Datalogic Jet - Manual

Datalogic Jet™ Ethernet Multi Cradle

The Datalogic Jet™ Ethernet Multi Cradle provides power for charging up
to four mobile computers simultaneously and also connects up to four
mobile computers to an Ethernet network.

Figure 1 – Datalogic Jet™ Ethernet Multi Cradle General View

Key:
A)

Link LED for Ethernet Port 1

B)

Speed LED for Ethernet Port 1

C)

Datalogic Jet™ Charging Status LED

D)

Power supply connector

E)

Ethernet Port 1 (with integrated Link and Speed LEDs)

F)

Ethernet Port 2 (with integrated Link and Speed LEDs)

822000751 (Rev. A)

The Ethernet cradle drivers are pre-installed on the Datalogic Jet™ and
initiate automatically when the Datalogic Jet™ is placed in a properly
connected Four Slot Ethernet cradle.

When the mobile computer is inserted into the Four Slot Ethernet cradle,
the LAN icon indicates that the mobile computer is connected to a
network.

NOTE

Ethernet communication requires Datalogic Jet™ PDA
SW version 5.41 or later. Verify the software version
by tapping on

Software – Version

in the Datalogic

default home page. Otherwise, search for the file

version.htm

under the Windows folder.

The green Speed LED lights to indicate that the transfer rate is 100 Mbps.
When it is not lit it indicates that the transfer rate is 10Mbps.

NOTE

The maximum bandwidth capacity for each Mobile
Computer is 12Mbps.

The yellow Link LED blinks to indicate activity, or stays lit to indicate that
a link is established. When it is not lit it indicates that there is no link.

The Speed LED and the Link LED integrated in Ethernet Port 1 and 2
function in the same way.

The Charging Status LED on the mobile computer shows the status of the
battery charging. The maximum time required to recharge a completely
run-down battery pack is about 2.5 hours for Li-Ion batteries. See
Datalogic Jet™ User’s Manual par. 3.5.1 for Charging Status LED
indications.

Correct Mobile Computer Insertion / Removal

Insert the mobile computer into a slot to begin charging and start
communication.

For correct insertion onto the cradle, insert the mobile computer from the
top of the cradle and push it down firmly.

Figure 2 - Mobile Computer Insertion

To remove the mobile computer from the Datalogic Jet™ Ethernet Multi
Cradle, simply pull it upwards while holding the cradle firmly down.

TECHNICAL FEATURES

Electrical Features

Power supply *

from 12 to 14 VDC ± 5%

Consumption

Max 4.2 A

Indicators

Ethernet Link LED (yellow)
Ethernet Speed LED (green)

Charge time (when PDA is off) max 2.5 hours (Li ION batteries)

Communication Features

Interface

Ethernet 10/100 Base T

Environmental Features

Working temperature

0° to +50°C / 32° to 140°F **

Storage temperature

-20° to +70°C / -4° to 158°F

Humidity

90% non condensing

Degree of protection

IP20

Mechanical Features

Dimensions

480 x 110 x 190 mm
18.89 x 4.33 x 7.48 in

Weight

about 2750 g / 97 oz

*

Recommended DL power supply: FPS18.

** Batteries must be charged at a temperature ranging from 0° to 45 °C

(+32° to 113°F).

F

E

D

B

A

C