COZY BFT101 - Manual
COZY BFT101 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – SAFETY INSTRUCTIONS - CONTINUED
- Page 5 – INSTALLATION; FIGURE 9
- Page 6 – INSTALLATION - CONTINUED; FIGURE 2; CLEARANCES; GAS INLET LOCATION
- Page 7 – NA
- Page 8 – PROPANE GAS
- Page 9 – FIGURE 3; INSTALLING VF-FSK FLOOR BASE KIT
- Page 10 – GAS CONNECTION; FIGURE 6; FIGURE 6A; BURNER ORIFICE
- Page 12 – PROPER OPERATION; CORRECT; LOW PRESSURE; CORRECT FLAME
- Page 13 – Apply Air; STEP 3 - PILOT CLEANING; MAINTENANCE; Burner may be cleaned by using a low pressure air hose, or soft brush.
- Page 14 – BLOWER INSTRUCTIONS; WIRING DIAGRAM / VFB BLOWER
- Page 17 – MODEL NUMBERS NAT BFT101 BFT201 BFT301
- Page 18 – TAMPERING IS DANGEROUS; IF YOU SMELL GAS, DON’T LIGHT IT; Do not try to light any appliance.
- Page 19 – LOUISVILLE TIN & STOVE COMPANY; LIMITED WARRANTY; TABLE A
BLUE FLAME
VENT FREE HEATERS
INSTALLATION AND
OPERATION INSTRUCTIONS
P/N 88950 / FEBRUARY 04
WARNING: If the information in this manual is not
followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
-
Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
-
WHAT TO DO IF YOU SMELL GAS:
•••••
Do not try to light any appliance.
•••••
Do not touch any electrical switch; do not use any
phone in your building.
•••••
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
•••••
If you cannot reach your gas supplier, call the fire
department.
-
INSTALLATION AND SERVICE MUST BE
PERFORMED BY A QUALIFIED
INSTALLER, SERVICE AGENCY OR THE
GAS SUPPLIER.
INSTALLER: Leave this manual
with the appliance.
CONSUMER: Retain this
manual for future reference.
INSTALLER MUST SHOW
HOMEOWNER PROPER
LIGHTING AND OPERATION
OF HEATER. HAVE THEM
COMPLETE AND RETURN
THE WARRANTY CARD.
This is an unvented gas fired heater. It uses air (oxygen) from the room in which it is installed. Provisions
for adequate combustion and ventilation air must be provided. See Pg. 4 & 5.
This unit is not approved for installation in greenhouses,or environments involving dusty, wet,
corrosive, or explosive conditions. Such conditions will invalidate the warranty and may create
unsafe conditions.
TYPE GAS
MODEL NUMBERS
NATURAL GAS
BFT101 BFT201 BFT301
PROPANE GAS
BFT102 BFT202 BFT302
This appliance may be installed in an aftermarket, permanently located, manufactured (mobile) home,
where not prohibited by local codes. This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other gases.
R
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
7) Installation and repair should be done by a qualified service person. The heater should be inspected before useand at least annually by a professional service person. More frequent cleaning may be required due to excessivelint from carpeting, bedding, material, etc. It is imperative that control ...
STEP 4. Compare the total Btu the area can support (from Step 2) to the total Btu in the area the heater will be installed(from Step 3). If the total from Step 2 is larger this is considered an unconfined space, if Btu total from Step 3 is larger thisis considered a confined space and provisions mus...
3) Protect heater from wind, high traffic areas, and drafts (such as doorways, locations that get direct air from a ceilingfan, etc.) as this will cause nuisance pilot outage. 4) All models may be wall mounted using the factory supplied (standard) wall mounting bracket. Additionally allmodels may be...
