Cisco 2500 Series - Manual
Cisco 2500 Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Removing AC and DC Power Supplies; Take the following steps to remove a power supply:
- Page 4 – Do not pull on the connector wires.
- Page 5 – Place the removed screw and power supply in an antistatic bag.; Installing AC and DC Power Supplies; Figure 5
- Page 6 – Replacing the Cover; Take the following steps to replace the cover:
- Page 8 – Connecting the DC Power Supply; DC Power Specifications; Follow the directions in this section to wire the terminal block.; Wire gauge for power connections
- Page 10 – Installing Power Requirements and System Identifier Labels; power supply to a DC power supply.
- Page 11 – Obtaining Service and Support; Cisco Connection Online; Note; offers programs that include direct access to CCO’s services.
- Page 12 – You can access CCO in the following ways:
1
Doc. No.
Cisco Systems, Inc.
All rights reserved.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
Cisco Systems, Inc.
Corporate Headquarters
Copyright © 1997
Installing Cisco AC and DC Power Supplies in
Cisco 2500 Series Routers
Product Numbers: PWR-2500-AC=, PWR-2500-DC=
This document describes how to replace the AC or DC power supply in Cisco 2500 series routers.
The AC and DC power supplies are spare parts items. The replacement of the power supply requires
removing the existing power supply and installing the replacement power supply. This procedure
does not apply to the Cisco 2517, 2518, or 2519 versions of the Cisco 2500 series routers.
This document includes the following sections:
•
Required Tools and Equipment, page 2
•
Removing the Cover, page 2
•
Removing AC and DC Power Supplies, page 3
•
Installing AC and DC Power Supplies, page 5
•
Replacing the Cover, page 6
•
Obtaining Service and Support, page 11
•
Cisco Connection Online, page 11
Warning
This waning symbol means danger. You are in a situation that could cause bodily injury.
Before you work on any equipment, you must be aware of the hazards involved with the electrical
circuitry and familiar with standard practices for preventing accidents. (To see translated versions of
this warning, refer to the Regulatory Compliance and Safety Information document that
accompanied the router.)
Warning
Only trained and qualified personnel should be allowed to install or replace this
equipment. (To see translated versions of this warning, refer to the Regulatory Compliance and
Safety Information document that accompanied the router.)
78-4144-01
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installing Cisco AC and DC Power Supplies in Cisco 2500 Series Routers 3 Removing AC and DC Power Supplies Warning Do not touch the power supply when the power cord is connected. For systems with a power switch, line voltages are present within the power supply even when the power switch is OFFand t...
4 Installing Cisco AC and DC Power Supplies in Cisco 2500 Series Routers Removing AC and DC Power Supplies Figure 2 Removing the Screw Step 2 Disconnect the power connector from the system board. (See Figure 3.) Grasp the sidesof the power connector and pull upward while rocking the connector side t...
Installing Cisco AC and DC Power Supplies in Cisco 2500 Series Routers 5 Installing AC and DC Power Supplies Figure 4 Removing the Power Supply Step 4 Place the removed screw and power supply in an antistatic bag. Installing AC and DC Power Supplies This section describes how to install AC and DC po...
