Cisco 2600 Series - Manual
Cisco 2600 Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Safety Warnings
- Page 3 – Safety with Electricity; Disconnect all power before doing the following:; — Installing or removing a chassis; Do not work alone if potentially hazardous conditions exist.; — Use caution do not become a victim yourself.; victim and then call for help.
- Page 4 – Preventing Electrostatic Discharge Damage; Required Tools and Equipment; This kit includes the following items:; Caution
- Page 5 – Medium-size Phillips screwdriver; Removing the Cover; Warning
- Page 7 – Removing the Power Supply; Take these steps to remove the power supply:
- Page 8 – Place the removed screw and power supply in an antistatic bag.; Installing the Redundant Power Supply Adapter Plate; Take these steps to install the Cisco RPS Adapter Plate:
- Page 10 – Replacing the Cover; Take the following steps to replace the cover:
- Page 11 – Obtaining Service and Support; Note; You can access CCO in the following ways:; Note
- Page 12 – Ordering Documentation
1
Doc. No.
Cisco Systems, Inc.
All rights reserved.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
Cisco Systems, Inc.
Corporate Headquarters
Copyright © 1998
Installing the Cisco RPS Adapter Plate
in Cisco 2600 Series Routers
Product Number: ACS-2600RPS=
This document describes how to install an adapter plate in Cisco 2600 series routers for use with the
Cisco Redundant Power System (RPS). The Cisco RPS provides power system redundancy to
external devices (such as routers, switches, or hubs). The system includes two fully redundant AC
input power modules and four DC output power modules for connection to external devices. The
Cisco RPS supports quasi-redundant and fully redundant power source configurations. To use the
Cisco RPS with Cisco 2600 series routers, you must remove the existing power supply and replace
it with a Cisco RPS adapter plate.
This document includes the following sections:
•
Safety Recommendations on page 1
•
Required Tools and Equipment on page 4
•
Removing the Cover on page 5
•
Removing the Power Supply on page 7
•
Installing the Redundant Power Supply Adapter Plate on page 8
•
Obtaining Service and Support on page 11
•
Cisco Connection Online on page 11
•
Ordering Documentation on page 12
Safety Recommendations
Follow these guidelines to ensure general safety:
•
Keep the chassis area clear and dust-free during and after installation.
•
Put the removed chassis cover in a safe place.
78-5172-01
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers Safety Recommendations • Keep tools away from walk areas where you or others could fall over them. • Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and rollup your sleeves. • Wear safety ...
Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers 3 Safety with Electricity To see translations of the remaining warnings that appear in this publication, refer to the RegulatoryCompliance and Safety Information document that accompanied the device. Safety with Electricity Follow t...
4 Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers Required Tools and Equipment Seul le système d’alimentation redondant Cisco (RPS modèle PWR600-AC-RPS) doit servir àalimenter le dispositif externe. Das externe Gerät darf nur mit einer redundanten Stromversorgung von Cisco, Model...
