Canon FS1- User Manual
Canon FS1– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FS 2 Controller; pin to 25 pin for a PC/AT or 25; Minolta Controller Setups; Mini Mars Controller; settings
- Page 3 – Appendix Appendix B - Reader & Camera Specifications 157; Mars 4 Controller; Kodak IMT Controller Setup; Visco Controller Setup
- Page 4 – M Asynchronous Protocol Adapter (API) Controller Setup; BlipChip* Controller Setup
- Page 5 – Appendix Appendix B - Reader & Camera Specifications 159
Appendix B
Reader &
Camera Specifications
Bell & Howell Classic Controller Setup
The Classic Controller is shipped with the Bell & Howell 5500 Reader/Printer:
1. Baud Rate. The controller is usually shipped with the baud rate set to 1200. Ask your Bell & Howell service
person what the baud rate is set to if 1200 does not work. The unit can be changed in the field to other baud
rates. 9600 is normally preferred.
2. Stop Bits = 1
3. Data Bits = 8
4. Parity = None
Canon Controller Setups
FS Controller
Ask your Canon service person to set up the following parameters for the FS controller or to tell you which parameters
are set up:
1. Baud Rate = 9600
2. Stop Bits = 1
3. Data Bits = 8
4. Parity = None
The cable is identical to the cable used for the Canon FS2 (see below).
)
Note:
The Canon FS does not come standard with an RS-232 interface. This interface needs to be ordered from
and installed by your local Canon dealer.
FS1 Controller
Ask your Canon service person to set up the following parameters for the FS1 controller or to tell you which parameters
are set up:
1. Baud Rate = 9600
2. Stop Bits = 1
3. Data Bits = 8
4. Parity = None
5. Search Mode = CANON
6. Listen/Talk = Yes
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
156 VersaCAR/VersaImage User’s Guide The cable needed is called a Null Modem cable and comes in two varieties 9 pin to 25 pin for a PC/AT or 25 pin to 25 pin for a PC/XT. Check with your computer vendor as to which type your computer has. These cables are generally available at stores like Radio S...
Appendix Appendix B - Reader & Camera Specifications 157 The cable is a 9 or 25-pin (PC end) to 15-pin cable normally available from your Minolta dealer. The cable is plugged into any COM port of your PC and into the 15-pin connector on the back of the Mini Mars controller. Mars 4 Controller The...
158 VersaCAR/VersaImage User’s Guide 4. Parity = None The cable needed is called a Null Modem cable and comes in two varieties 9 pin to 25 pin for a PC/AT or 25 pin to 25 pin for a PC/XT. Check with your computer vendor as to which type your computer has. These cables are generally available at st...
