Canon 247 - Manual

1

KDB996369 Check List

FCC ID: AZD247

Applicant: Canon Inc

This transmitter complies with KDB996369 D03 as indicated below:

Modular approval requirement

Applicable

Not Applicable

2.2 List of applicable FCC rules

List the FCC rules that are applicable to the modular transmitter.

These are the rules that specifically establish the bands of

operation, the power, spurious emissions, and operating

fundamental frequencies. DO NOT list compliance to

unintentional-radiator rules (Part 15 Subpart B) since that is not a

condition of a module grant that is extended to a host manufacturer.

See also Section 2.10 below concerning the need to notify host

manufacturers that further testing is required.

Please refer to User

Manual.

2.3 Summarize the specific operational use conditions

Describe use conditions that are applicable to the modular

transmitter, including for example any limits on antennas, etc. For

example, if point-to-point antennas are used that require reduction

in power or compensation for cable loss, then this information

must be in the instructions. If the use condition limitations extend

to professional users, then instructions must state that this

information also extends to the host manufacturer’s instruction

manual. In addition, certain information may also be needed, such

as peak gain per frequency band and minimum gain, specifically

for master devices in 5 GHz DFS bands.

2.4 Limited module procedures

If a modular transmitter is approved as a “limited module,” then the

module manufacturer is responsible for approving the host

environment that the limited module is used with. The

manufacturer of a limited module must describe, both in the filing

and in the installation instructions, the alternative means that the

limited module manufacturer uses to verify that the host meets the

necessary requirements to satisfy the module limiting conditions.

A limited module manufacturer has the flexibility to define its

alternative method to address the conditions that limit the initial

approval, such as: shielding, minimum signaling amplitude,

buffered modulation/data inputs, or power supply regulation. The

alternative method could include that the limited module

manufacturer reviews detailed test data or host designs prior to

giving the host manufacturer approval.

This limited module procedure is also applicable for RF exposure

evaluation when it is necessary to demonstrate compliance in a

specific host. The module manufacturer must state how control of

the product into which the modular transmitter will be installed

will be maintained such that full compliance of the product is

always ensured. For additional hosts other than the specific host

originally granted with a limited module, a Class II permissive

change is required on the module grant to register the additional

host as a specific host also approved with the module.