Bryant TZEMT400AB32MAA - Manual
Bryant TZEMT400AB32MAA – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WARNING; Physical Installation and Wiring; If your existing thermostat is battery powered:
- Page 3 – Remove existing wall plate.; Detach all wires from wall plate.; MERCURY NOTICE; Identify your; Improper system type selection can lead to equipment damage
- Page 4 – Mark two mounting holes using new wall plate.; Anchors
- Page 5 – Find the chart below that has your correct System Type.; System Type - Heat Pump
- Page 6 – Attach all wires securely to the new thermostat.; Note: A wire must be connected to “24COM” to power the thermostat.; CAUTION: EQUIPMENT DAMAGE HAZARD; - Improper wiring can lead to equipment damage.; CUT JUMPER; Turn power to heating and cooling system back on.; Tuck wiring fl at inside the wall plate.
- Page 7 – , perform additional step; Set Time and Date; button; button; System Settings at Thermostat; between the system types.
- Page 8 – Electric Furnace
- Page 9 – Perform System Checkout; FAN; MODE; Test Heating Operation
- Page 10 – Prepare the bridge for enrollment.; Enroll Thermostat into Schlage LiNK; System; Enroll the thermostat into the bridge.; If you are using a controller that is not a Schlage LiNK; After you begin the enrollment process, you have; MENU; Gate; Done; Scroll; Verify enrollment of the thermostat.; ZNID
- Page 11 – Establish Online Control of the Thermostat.; Plug the Ethernet and power cord back into the bridge.; Climate; tab and follow the onscreen instructions.
Thermostat Guide
Model TZEMT400AB32MAA
Tools Needed
1/8”
#2
Customer Service Phone #: (877) 288-7707
Physical Installation and Wiring
Pages 2-6
System Settings at Thermostat
Pages 7-8
Perform System Checkout
Page 9
Enroll Thermostat into Schlage LiNK
TM
System
Pages 10-11
Table of Contents
NOTE:
This thermostat is not compatible with dual
fuel systems (heating system with both heat pump
and gas furnace), unless the system is controlled
with a dual fuel accessory relay kit. If you are
unsure whether your dual fuel system is controlled
with this accessory or if you need a dual fuel kit,
please contact a qualifi ed heating and cooling
contractor.
©2009 Schlage Lock Company
Thermostat Guide Rev. 5/09-Alpha
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 5 WARNING Voltage hazard. Can cause electrical shock or equipment damage. Turn off all power to heating and cooling equipment before beginning installation. 2 Remove the existing thermostat cover from the wall plate.Leave wires attached. Consult instructions that came with existing thermostat as n...
7 Remove existing wall plate. Note: During this process, make sure that the wires do not pull back into wall opening. Detach all wires from wall plate. a. Remove all screws attaching the wall plate to the b. wall and remove wall plate.See “MERCURY NOTICE” to the right. c. 3 MERCURY NOTICE When this ...
11 Install new wall plate. Pull wires through hole in center of wall plate. a. Locate the new wall plate over existing opening. b. Attach wall plate to wall using two screws provided. Do not overtighten. c. 24COM 24RC 24RH W1 W2/0 G Y1 Y2 8 Separate the face of the TZEMT400 thermostat from the wall ...
