Zanussi ZWP581- Manuals

Page 2 - Contents; Subject to change without notice.; Safety information

Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4How to run a wash cycle? _ _ _ _ _ _ _ _ _ _ 5Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ 7Ca...

Page 3 - Safety; Installation

• Obey the maximum load volume of 5,5 kg (refer to the “Pro- gramme chart” chapter). • If the supply cord is damaged, it must be replaced by the manu- facturer, its service agent or similarly qualified persons in order toavoid a hazard. • The operating water pressure (minimum and maximum) must be be...

Page 4 - Product description

• Before you connect the appliance to new pipes or pipes not used for a long time, letthe water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. Use Warning! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this applia...

Page 5 - How to run a wash cycle?; Using for the first time

Control panel 1 2 3 4 5 6 7 1 Programme selector 2 DELAY START button 3 Lights of cycle progress 4 START/PAUSE button 5 EXTRA RINSE button 6 OPTIONS button 7 SPIN button Dispenser box Prewash Wash Softener (do not fill above the MAX symbol M ) How to run a wash cycle? Using for the first time • Ensu...

Page 6 - Daily use

Daily use Loading washing • Open the lid of the appliance. • Open the drum by depressing thelocking button A:The two shuttersunlock automati-cally. • Load the washing, close the drum and the lid of your washingmachine. Warning! Before closing the lid of your appliance, ensure that the drum is proper...

Page 7 - Washing programmes

• To change the timer delay period, you must go through the “Stop” position and re- programme your cycle. The lid will be locked during the delayed starttime. If you need to open it, you must first pausethe appliance by pressing the “Start/Pause” pushbutton. After closing the lid again, pressthe “St...

Page 9 - Care and cleaning; Unplug the appliance before cleaning.; Descaling the appliance

Programme / Type of washing Load Available options Drain : Runs an empty cycle after a Rinse hold option. 5,5 kg Spin : A spin cycle from 500 to 850 rpm for model ZWP581/ 1000 rpm for modelZWQ5102,ZWQ5103/ 1200 rpm for modelZWQ5122 after a Rinse hold option. 5,5 kg Delay start 1) Standard programmes...

Page 10 - Water inlet filters; Operating Problems

7 8 9 10 CLACK 11 CLACK Water inlet filters To clean, proceed as follows : Precautions to be taken against frost If your appliance is exposed to temperatures be-low 0°C, the following precautions must be tak-en: • Close the tap and disconnect the inlet hose. • Place the end of this hose and the drai...

Page 12 - Helpful hints and tips; The laundry load

Problems Causes The “Start/Pause” push- button 1) flashes red 2) : • the lid is not closed properly, • the drainage filter is obstructed, • the drain hose is blocked or bent, • the drain hose is fixed to high (see "Installation"), • the drainage pump is blocked, • the standpipes blocked, • t...

Page 14 - Unpacking

Program m es Loa d (kg ) E n e rgy consu m ption (kWh ) Water c o n s um pti o n (li tre) A ppr oxima te pr ogr a mm e dur a tion ( m inu te s ) R e maining moisture (%) 1) ZWP581 R e maining moisture (%) 1) ZWQ 510 2, ZWQ51 0 3 R e maining moisture (%) 1) ZW Q 5 1 2 2 Wool/Handwash 30 °C 1 0.35 52 ...

Page 15 - Water supply; Check if the; Drainage; Environment concerns

C Keep the transit boltsfor when you movethe appliance. To install the appli-ance at the same lev-el as neighboring fur-niture, cut these plas-tic pieces. Water supply 90 O 90 O 90 O In case of necessitymove the inlet hose inthe direction shownon picture. To makethis loose the inlethose ring nut and...