Zanussi ZWN 6120 L- Manuals

Page 2 - General safety

Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Helpful hi...

Page 4 - Product description; Detergent dispenser drawer

Product description 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adjustable feet 1 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available)...

Page 6 - Load the laundry

Indicator pilot light (7) When selecting a washing programme both lights 7.1 and 7.2 illuminate. After having pressed the button 5 the only light corre- sponding to the running phase stays on. The machine starts working and the door is locked. The light 7.3 illuminates at the end of the washing cy- ...

Page 7 - Flap for powder or liquid detergent; Select the required programme by turning the

Flap for powder or liquid detergent UP- The flap position if using POWDER detergent DOWN - The flap position if using LIQUID detergent during main wash If the flap is not in the desired position: MAX • Pull out the dispenser drawer until it stops. The flap is down and you wish to use powder detergen...

Page 9 - At the end of the programme; Helpful hints and tips; Sorting out the laundry

If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dialto . After a few minutes the door can be opened (pay attention to the water level and temperature!). After closing the door, it is necessary to select the pro- gramme and options again ...

Page 10 - Washing programmes; Type of Laundry

Ink: depending on the type of ink, moisten the fabric firstwith acetone 1) , then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thor- oughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. Detergents ...

Page 13 - Care and cleaning; Descaling; Cleaning the drawer recess

Programme - Maximum and Minimum Temperature - Cycle De- scription - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Com- partment SPIN Drain and long spin Maximum spin speed at 1200 rpm Max. load 8 kg Separate spin for hand washed garments and after programmes with the ...

Page 14 - Cleaning the pump

Cleaning the pump The pump should be inspected regularly and particularly if:• the appliance does not empty and/or spin;• the appliance makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump; • a problem with water draining is detected (see chapter “W...

Page 16 - What to do if...; Problem

What to do if… Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red pilot light of ...

Page 18 - Technical data

Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rota- tion of the drum. This may happen several times before the ...

Page 19 - Consumption values; Programme; Installation; Unpacking

Consumption values Programme Energy consumption (kWh) 1) Water consumption (litre) 1) Programme duration (minutes) 1) White Cottons 90 °C 2.1 65 145 Cottons 60 °C 1.4 63 120 Cottons 40 °C 0.6 63 140 Synthetics 40 °C 0.45 37 85 Delicates 40 °C 0.6 63 70 Wool/ Handwash 30 °C 0.25 55 30 1) The consumpt...

Page 21 - standpipe; Loop

The other end of the inlet hose which connects to the appliance can be turned as showed in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After positioning the inle...

Page 22 - Environment concerns

If the outlet spigot has not been used before, remove any blanking plug that may be in place. Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose (see above) to prevent waste from the sink enter- ing the appliance. If you intend to drain the hose fro...