Zanussi ZWF185W- Manuals

Page 2 - Downloaded From WashingMachine-Manual.com Manuals

THE CONTENTS SECTION 1:BEFORE USING • Safety warnings • Recommendations SECTION 2:INSTALLATION • Removal of transportation screws • Adjustment of feet • Electrical connection • Water supply connection • Water drain connection SECTION 3:TECHNICAL SPECIFICATIONS SECTION 4:CONTROL PANEL • Start/Pause b...

Page 4 - SECTION 2: INSTALLATION; REMOVAL OF TRANSPORTATION SCREWS; Do not install your machine on rugs or similar surfaces.

•••• If you will not use your machine for a long time, unplug your machine, close the water supply and leave the door open in order to keep the inside of the machine dry and for prevention from unpleasant odour. •••• As a result of the quality control procedures, a certain amount of water may remain...

Page 5 - ELECTRICAL CONNECTION

•••• You can adjust the balance of your machine from its feet. •••• First, loosen the plastic adjustment nut. •••• Adjust by rotating the feet upwards or downwards. •••• After the balance has been reached, tighten the plastic adjustment nut again by rotating it upwards. •••• Never put cartons, woode...

Page 6 - WATER DRAIN CONNECTION; Never attempt to extend the water drain hose by adding extra parts.

• Water pressure of 1-10 bars from your tap will enable your machine to work more efficiently.(1 bar pressure means water flow of more than 8 liters in 1 minute from a fully opened tap). • After connections are completed, check for the non-leakage of the connection joints by turning on your tap comp...

Page 8 - SECTION 4:CONTROL PANEL

SECTION 4:CONTROL PANEL 1 2 3 4 5 6 7 8 1-Detergent drawer 5-Program knob 2-Start/pause light 6-Start/pause button 3-Function indicator lights 7-Function buttons 4-Program ready light 8-Program end light 7 Downloaded From WashingMachine-Manual.com Manuals

Page 10 - Extra rinse; You can have one more rinsing done in addition to the rinses

If you do not want your sensitive clothes to be spinned or you want them to be spinned sensitively, turn the program knob to O (off) position. Bring the program knob on one of the draining or spinning programs you desire and press the start/pause button. If the program you have selected is a drain p...

Page 12 - 3 Draining; First wash cycle; Never wash your white and coloured clothes together.

O Stop 1 Cotton 90˚ 2 Cotton 60˚(Prewash) 3 Cotton 60˚ 4 Cotton 40˚ 5 Eco wash 6 Cotton 30˚ 7 Quick wash 8 Cotton cold 9 Mix wash 10 Synthetic 60˚ 11 Baby wash 12 Synthetic 40˚ 13 Sport clothes 14 Synthetic cold 15 Curtain wash 16 Delicate 30˚ 17 Delicate cold 21 Rinsing 18 Hand wash 19 Wool 30˚ 22 ...

Page 14 - RUNNING THE MACHINE; Program selection and features

• You can use fluid detergents in all programs without pre-washing. For this, mount the fluid detergent level plate in the second compartment of the detergent drawer and arrange the amount of fluid detergent according to the levels on this plate. RUNNING THE MACHINE Program selection and features Se...

Page 18 - Remove the water inlet hose.; PUMP FILTER; Open the kickplate’s cover, by pulling the handle.

• Remove the water inlet hose. • Remove the filters found on the water inlet valves by using a pincer and wash thoroughly with a brush. • Clean the filters of the water inlet hoses located on the tap side by removing manually together with the seal. • After you clean the filters, you can fit them th...

Page 19 - Danger of being scalded!; DETERGENT DRAWER; Wash will an old toothbrush and excessiveamount of water.

WARNING! Danger of being scalded! Since the water inside the pump maybe hot, wait for it to cool. DETERGENT DRAWER Detergents may form a sediment in your detergent drawer or in housing of the detergent drawer in time. To clean the sediment, pull out the detergent drawer from time to time.To pull out...

Page 20 - Plug in the machine.; THE DRUM; REMOVE OF LIME FROM YOUR MACHINE

SIPHON PLUG Pull out the detrgent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly. THE CABINET Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning subst...

Page 22 - Mould; SECTION 8: AVOIDING MINOR FAULTS

Mould : Mould stains should be cleaned as soon as possible. The stain should be washed with detergent, and if it does not disappear, it should be wiped with oxygenated water (in proportion of 3%). Ink: Hold the stained area under cold water and wait until the inky water completely runs off. Then rub...

Page 23 - Your fuse is defected.

FAILURE PROBABLE CAUSE METHODS OF ELIMINATION It is unplugged. Insert the plug into the socket. Your fuse is defected. Change your fuse. The electric power is off. Check the electric power. Start/pause button has not been pressed. Press the start/pause button. The program knob is in O(off) status. B...

Page 26 - SECTION 9: AUTOMATIC FAILURE DETECTION SYSTEM

FAILURE PROBABLE CAUSE METHODS OF ELIMINATION The spining process is not done or starts with delay . No failure. The unbalanced load control may works in that way. The unbalanced load control system will try to distribute your clothes in a homogenous manner. After your clothes are distributed, passa...

Page 29 - SECTION 10: INTERNATIONAL WASHING SIGNS; Washing

SECTION 10: INTERNATIONAL WASHING SIGNS Washing temparature. Do not wash (hand wash) Lukewarm iron. Medium hot iron. Hot iron. Do not iron. Do not tumble dry. Hang to dry. Drip dry. Dry flat. Do not bleach. Handy to bleach. All of these are dry cleaning symbols. The letters are to instruct the clean...