Zanussi ZRG16606WA- Manuals

Page 2 - Contents; Safety information

Contents Safety information 2 Safety instructions 3 Operation 4 First use 5 Daily use 5 Hints and tips 5 Care and cleaning 6 Troubleshooting 7 Installation 9 Technical information 12 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read...

Page 3 - Safety instructions; Installation

• Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. • Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recomm...

Page 4 - Operation

Use WARNING! Risk of injury, burns, electrical shock or fire. • Do not change the specification of this appliance. • Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. • Be careful not to cause damage to the refrigerant ci...

Page 5 - First use; Cleaning the interior; Daily use; Movable shelves; Hints and tips; Normal operating sounds

However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature • how often the door is opened • the quantity of food stored • the location of the appliance. If the ambient temperature is high or the appliance is fully loaded, and ...

Page 6 - Care and cleaning; General warnings

• A faint click noise from the temperature regulator when the compressor switches on or off. Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and t...

Page 7 - Defrosting of the refrigerator; Clean the appliance and all accessories.; Troubleshooting

The equipment has to be cleaned regularly:1. Clean the inside and accessories with lukewarm water and some neutral soap. 2. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. 3. Rinse and dry thoroughly. 4. If accessible, clean the condenser and the compress...

Page 9 - Replacing the lamp; Replace the used lamp with a new lamp of; Closing the door; If necessary, replace the defective door; Positioning; Turn the spacer to the right position.

Problem Possible cause Solution The door has been opened of- ten. Open the door only if necessary. There is no cold air circulation in the appliance. Make sure that there is cold air cir- culation in the appliance. If the advice does not lead to the desired result, contact the nearest Authorised Ser...

Page 10 - Unscrew the screws of the door bottom

2 4 1 3 Levelling When placing the appliance ensure that it stands level. This can be achieved by two adjustable feet at the bottom in front. Location CAUTION! It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation...

Page 11 - Remove and install the handle on the; Electrical Connection

1 2 3 10. Tighten the hinge. 11. Put the top in position. 12. Push front the top. 13. Screw both screws on the rear side. 14. Remove and install the handle on the opposite side. 1 2 3 Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The do...

Page 12 - Technical information; Technical data; ENVIRONMENT CONCERNS

letter “E“ or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands...