Page 2 - Children and vulnerable people safety
Contents Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Product description _ _ _ _ _ _ _ _ _ _ _ _ _ 4Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _...
Page 4 - Product description; Switching on
Service • Any electrical work required to do the servic- ing of the appliance should be carried out bya qualified electrician or competent person. • This product must be serviced by an author- ized Service Centre, and only genuine spareparts must be used. Environment Protection This appliance does n...
Page 6 - Care and cleaning; Periodic cleaning
• The thermic dilatation might cause a sudden cracking noise. It is natural, not dangerousphysical phenomenon. This is correct. • When the compressor switches on or switches off, you will hear a faint "click" ofthe temperature regulator. This is correct. Hints for energy saving • Do not open...
Page 7 - What to do if...; Before troubleshooting,
mal use. The defrost water drains out through adrain hole into a special container at the backof the appliance, over the motor compressor,where it evaporates. It is important to peri-odically clean the de-frost water drain holein the middle of therefrigerator compart-ment channel to pre-vent the wat...
Page 8 - Replacing the lamp; Disconnect the appliance.; Closing the door; Clean the door gaskets.; Technical data
Problem Possible cause Solution Products prevent that water flowsinto the water collector. Make sure that products do nottouch the rear plate. Water flows on the ground. The melting water outlet does notflow in the evaporative tray abovethe compressor. Attach the melting water outlet to theevaporati...
Page 9 - Installation; Positioning; Location
The technical information are situated in the rat-ing plate on the internal left side of the appli-ance and in the energy label. Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing theappliance. Positioning In...
Page 11 - Door reversibility
Door reversibility Important! To carry out the following operations, we suggest that this be made withanother person that will keep a firm hold on thedoors of the appliance during the operations. To change the opening direction of the door,do these steps: • Remove the plug from the power socket. • T...
Page 12 - Environmental concerns
• The edges of the doors run parallel to the side edge of the appliance. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly.It is advisable to wait at least four hours beforeconnecting the appliance to allow the oil to flowback in the compressor.If the ambient temperat...