Page 2 - Contents
Thank you for selecting ourappliance We wish you lots of enjoyment with your newappliance and we hope that you will considerour brand again when purchasing householdappliances.Please read this user manual carefully andkeep it throughout the product life cycle as areference document. The user manual ...
Page 3 - Safety information; Correct use
Safety information In the interest of your safety and to ensure thecorrect use, before installing and first using theappliance, read this user manual carefully, in-cluding its hints and warnings. To avoidunnecessary mistakes and accidents, it is im-portant to ensure that all people using theapplianc...
Page 4 - Installation; Control panel
Installation • Check your dishwasher for any transport damage. Never connect a damaged ma-chine. If your dishwasher is damaged con-tact your supplier. • All packaging must be removed before use.• Any electrical and plumbing work required to install this appliance must be carried out bya qualified an...
Page 6 - Washing programmes
Indicator lights Wash indicator light Illuminates when a washing programme is set and re-mains illuminated for all the duration of the washingprogramme.Turns off when the washing programme has ended. End of programme Illuminates when the washing programme has ended.Switch off the dishwasher by retur...
Page 7 - First use
Programme Degree of soil Type of load Programme description Bio 50° 2) Normal soil Crockery and cutlery PrewashMain wash1 intermediate rinseFinal rinseDrying Rinse and Hold Any.Partial load (to be completed later in the day). 1 cold rinse (to avoid foodscraps from stickingtogether).This programme do...
Page 8 - Set the water softener
If you decide in future to use separated deter-gents, we advise that you:– Fill up the salt and rinse aid container.– Adjust the water hardness setting to the highest level and perform 1 normal washingprogramme without loading any dishes. – Adjust the water hardness setting according to the hardness...
Page 9 - Filling with dishwasher salt
Setting the water softener manually (see table) Set switch to position 1 or2 The water softener is factory set at position 2. Setting the water softener electronically (see table) The water softener is factory set at position 5.The dishwasher must be switched off . Press and hold the start/cancel bu...
Page 12 - Loading cutlery and dishes
Loading cutlery and dishes Sponges, household cloths and any object thatcan absorb water may not be washed in thedishwasher.• Before loading the dishes, you should: – Remove all left over food and debris.– Soften remnants of burnt food in pans • When loading the dishes and cutlery, please note:– Dis...
Page 14 - Use of detergent
To move to the higher position proceed as follows: 1. Pull out the basket until it stops.2. Carefully lift both sides upwards until the mecha- nism is engaged and the basket is stable. To lower the basket to the original position proceedas follows: 1. Pull out the basket until it stops.2. Carefully ...
Page 15 - Unloading the dishwasher; Care and cleaning; Cleaning the filters
For programmes with pre-wash add an additionaldetergent dose in com-partment B . When using detergenttablets: place detergenttablets in compartment A . Close the lid. Unloading the dishwasher • Hot dishes are sensitive to knocks. The dishes should therefore be allowed tocool down before removing fro...
Page 16 - Cleaning the spray arms; External cleaning
Clean filters A , B and C thoroughly under runningwater. Turn the handle about 1/4turn anticlockwise and re-move filters B and C . Remove filter A from the base of the washing com-partment. Put the flat filter A back in the base of the washingcompartment and ensurethat it fits perfectly underthe two...
Page 17 - Frost precautions; Environmental concerns; Packaging material
2. Leave the door ajar to prevent the forma- tion of any unpleasant smells. 3. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location wherethe temperature is below 0°C. If this isunavoidable, empty the machine, close the ap-pliance door, disconnect the water...
Page 18 - Something not working
Something not working The dishwasher will not start or stops duringoperation.Certain problems are due to the lack of simplemaintenance or oversights, which can besolved with the help of the indications describedin the chart, without calling out an engineer. Switch off the dishwasher, open the door a...
Page 20 - Technical data; Hints for test institutes
Technical data Dimensions Width x Height x Depth (cm) 60,0 x 85,0 x 61,0 Electrical connectionVoltage - Overall power - Fuse Information on the electrical connection is given on the rating plate on theinner edge of the dishwasher’s door. Water supply pressure Minimum - Maximum(MPa) 0,05 - 0,8 Capaci...
Page 21 - Water connection
Test in accordance with EN 50242 must be carried out when the salt container and rinseaid dispenser have been filled with salt and rinse aid respectively and using the test pro-gramme (see "Consumption values"). Full load: 12 standard place settings Amount of detergent required 5 g + 25 g (T...
Page 24 - Levelling; Guarantee/Customer Service; Belgium
Levelling Good levelling is essential for correct closure andsealing of the door.When the appliance is correctly levelled, the door willnot catch on either side of the cabinet. Guarantee/Customer Service Belgium DECLARATION OF GUARANTEE TERMS.Our appliances are produced with the greatestof care. How...
Page 26 - Luxembourg; European Guarantee
Belgium Tel.: Fax.: Electrolux Home ProductsBelgium ELECTROLUXSERVICE Bergenses-teenweg 719 1502 Lem-beek Consumer services 02/363.04.44 02/363.04.0002/363.04.60 E-mail: [email protected] Luxembourg Tel.: Fax.: Grand-Duché de Luxem-bourg ELECTROLUXHOME PRODUCTS Ruede Bitbourg. 7 L-1273...