Zanussi ZCG61266WA- Manuals

Model de- nomination and PNC number ZCG61226XA 943006104 ZCG61206WA 943006107 ZCG61206DA 943006108 ZCG61266WA 943006276 ZCG61216DA 943006110 ZCG61236XA 943006138 ZCG61256WA 943006139 ZCG61256XA 943006140 ZCG61266WA 943006150 ZCG61266XA 943006152 ZCG61236WA 943006269 ZCG62226XA 943006388 Hob thermo- ...

Cooking surface layout 1 2 3 5 4 1 Auxiliary burner 2 Steam outlet - number and position depend on the model 3 Semi-rapid burner 4 Semi-rapid burner 5 Rapid burner Accessories • Wire shelf For cookware, cake tins, roasts. • Baking tray For cakes and biscuits. • Turnspit For roasting larger joints of...

Ignition of the hob burner Always light the burner before you put on the cookware. WARNING! Be very careful when you use open fire in the kitchen environment. The manufacturer declines any responsibility in case of the flame misuse. The spark generator can start automatically when you switch on the ...

WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. Hob - Hints and tips WARNING! Refer to Safety chapters. Cookware WARNING! Do not put the same pan on two burners. WARNING! Do not put unstable or damaged pots on the burners to prevent from spill and inj...

1. Remove the pan supports to easily clean the hob. Be very careful when you replace the pan supports to prevent the hob top from damage. 2. The enamel coating occasionally can have rough edges, so be careful when you wash the pan supports by hand and dry them. If necessary, remove stubborn stains w...

holes and turn the lnob for the gas to the flame position. Turning off the grill burner To put out the flame, turn the knob to the offposition . Oven - Clock functions Minute Minder This function has no effect on the operation of the appliance. Turn the knob for the timer as far as it goes, then tur...

A 5. Install the first fork on the spit, then put the meat on the turnspit and install the second fork. Make sure that the meat is in the middle of the spit. 6. Use the screws to tighten the forks. 7. Put the tip of the spit into the turnspit hole. Refer to "Product description" chapter. 8. ...

Cakes Food Quantity (kg) Ther- mostat posi- tion Time (min) Grill posi- tion Grilling time (min) Total prepara- tion time (min) Shelf posi- tion Flat cake 1) 0.6 - 1.0 3 30 - 35 min. 5 - 10 35 - 45 3 Sponge cake 1.0 - 1.5 3 105 - 110 - - 105 - 110 2 Feter Mshal- ted 1) 1.0 - 1.5 5 40 - 45 min. 5 - 1...

Notes on cleaning • Clean the front of the appliance with a soft cloth with warm water and a cleaning agent. • To clean metal surfaces, use a usual cleaning agent. • Clean the appliance interior after each use. Fat accumulation or other food remains may result in a fire. • Clean stubborn dirt with a...

4. Put the door on a soft cloth on a stable surface. 5. Use a screwdriver to remove 2 screws from bottom edge of door. 1 1 6. Use a spatula made of wood or plastic or equivalent to open the inner door. Hold the outer door, and push the inner door against the top edge of the door. Lift the inner door...

Problem Possible cause Remedy There is no spark when you try to activate the spark generator. Burner cap and crown are placed incorrectly. Place the burner cap and crown correctly. The flame extinguishes immedi- ately after ignition. Thermocouple is not heated up sufficiently. After lightning the fl...

Installation WARNING! Refer to Safety chapters. Location of the appliance You can install your freestanding appliance with cabinets on one or two sides and in the corner. Keep a distance of about 1 cm between the appliance and the back wall to make sure that the lid opens. For minimal distances for ...

Adjusting the minimum gas level on the hob burner 1. Disconnect the appliance from the electricity. 2. Remove the knob for the hob. If there is no access to the bypass screw dismount the control panel before adjustment start. 3. With a thin and flat screwdriver adjust the bypass screw A. The model d...

1 2 4. Release the burner injector with a 7 mm socket spanner and replace it with a right one. Assemble the burner in a revers sequence.Replace the gas type sticker near the gas supply ramp with the one related to the new gas type. Adjusting the minimum gas level on the oven burner 1. Disconnect the...

A 2. Release the burner injector with a 7 mm socket spanner and replace it with a right one. 3. Assemble the burner in a reverse sequence. Before you fix the screw, make sure that the burner is pushed correctly to the back panel. Test the grill injectors. Levelling CAUTION! Remove all the accessorie...

This appliance is supplied with a main plug and a main cable. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not di...