Page 3 - SAFETY INSTRUCTIONS
– areas for communal use in blocks of flats or in launderettes. • Do not exceed the maximum load of 8 kg (refer to the "Programme chart" chapter). • The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa). • The ...
Page 14 - PRODUCT DESCRIPTION
2 N 1 E D C Counter-magnet The appliance is pre set for a magnetic closure. For a correct closure: 1. Position the screw C and the counter-magnet D on the magnetic plate N. Lean the cupboard door against the screw until it leaves a mark. 2. Open the cupboard door and screw the coun- ter-magnet D (st...
Page 15 - CONTROL PANEL
CONTROL PANEL CONTROL PANEL DESCRIPTION 1 10 7 6 8 9 11 5 2 3 4 The child lock option is set by holding pressed the relative button for at least 3 seconds. 1 Programme dial 2 Display 3 Delay Start touch button 4 Flextime touch button 5 Start/Pause touch button 6 Stains touch button and permanent Chi...
Page 16 - DIAL AND BUTTONS
Door locked indicator. Delay start indicator. The digital indicator can show:• Reset position ( ). • Programme duration (e. g. ). • Delay time (e. g. ). • Cycle end ( ). • Warning code (e.g. ). • Error indicator ( ). Time Manager indicator. Anti-stain indicator. Extra Rinse indicator. Add garments i...
Page 18 - PROGRAMMES
FLEXTIME With this option you can reduce the programme duration depending on the load size and the degree of soiling.When you set a washing programme, the displayshows the default duration and dashes. Touch Flextime button to reduce the programme duration according to your needs. The display shows t...
Page 21 - SETTINGS
Programme Spin Rinse Hold No spin Night Extra Rinse Prewash Stains 1) Delay Start Flextime CottonsEco ■ ■ ■ ■ ■ ■ ■ ■ ■ Synthetics ■ ■ ■ ■ ■ ■ ■ ■ ■ Delicates ■ ■ ■ ■ ■ ■ Easy Iron ■ ■ ■ ■ ■ ■ ■ Mixed ■ ■ ■ ■ ■ ■ ■ ■ Spin/Drain ■ ■ ■ Rinse ■ ■ ■ ■ ■ MachineClean ■ Duvet ■ ■ Daily Wash ■ ■ ■ ■ ■ ■ ■ ...
Page 26 - HINTS AND TIPS
The display shows the end of the last programme. Turn the programme dial to set a new cycle. If the dial is rotated to the "Reset" position , the appliance automatically turns off in 30 seconds. If you set a programme or an option that ends with water in the drum, the Stand-by function doesn...
Page 27 - CARE AND CLEANING
• Always start a washing programme with the maximum load of laundry allowed. • If you pre-treat the stains or use a stain remover, set a programme with a low temperature. • To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water hardness". ...
Page 31 - TROUBLESHOOTING
CLEANING THE INLET HOSE AND THE VALVE FILTER 1 2 3 45° 20° EMERGENCY DRAINIf the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain pump' paragraph. If necessary, clean the pump.When you drain the water with the emergency drain procedure, you must activa...
Page 35 - CONSUMPTION VALUES
CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant standards. Different cau- ses can change the data: the quantity and type of laundry and ambient temperature. Wa- ter pressure, the supply voltage and the temperature of inlet water may also affect the washing progra...
Page 37 - ENVIRONMENTAL CONCERNS
Power consumption of the off-mode in W 0.30 Power consumption in left-on mode in W 0.30 Water consumption in litres per year, based on 220 standard wash- ing cycles for cotton programmes at 60 °C and 40 °C at full and partial load. Actual water consumption will depend on how the appli- ance is used....