Yamaha NS IC400 - Manuals - manualsarea.com

Page 2 - Read these precautions carefully before setting up your N; Long-term use and vibrations may cause them to pull free.; CON

1 En Read these precautions carefully before setting up your N S -IC400 speakers. • When mounting these speakers, be sure to work with two or more persons for safety. • Do not attach them to thin plywood or soft ceiling surface materials as the screws may tear free, causing the speakers to fall and ...

Page 3 - CONTENT

2 En Eng lish S tereo For best stereo performance, install the left and right speakers at equal distance from the listening position. Each speaker should be separated by a distance of 1.8 – 3.0 m (6 – 10 ft). CONTENT S CON S UMER PRECAUTION S ............................................................

Page 4 - PREPARATION; Home Theater (when using as; urround; TV; Hallway; Example

3 En PREPARATION Home Theater (when using as surround speakers) Use these speakers for left and right surround channels. S urround speakers should ideally be placed behind the listening area, at least as far apart as the front speakers and up to 60 additional centimeters (2 additional feet) apart pe...

Page 5 - Unpacking; After unpacking, check that the following items are contained.; Tools needed for installation

4 En Eng lish PREPARATION N S -IC400 S peaker × 2 S peaker grille × 2 Cutout template × 1 Unpacking After unpacking, check that the following items are contained. Tools needed for installation When installing the speakers to the ceiling, you will need to prepare the following tools. * Use an appropr...

Page 6 - CAUTION; • When installing your N; NOTE; • If you wish to paint the speaker grille, refer to page 10; “PAINTING THE; Ceiling board thickness and clearance space above ceiling; ee the following chart for; IN

5 En The following is the recommended procedure for installing the speakers in a ceiling. Please read it carefully before installation.• Before you begin installation, read this owner's manual completely and consult your local building codes. If you have any doubt, contact your dealer or a qualified...

Page 7 - INSTALLATION; How to install; • When using a drill or cutting tool, use; • If there is any obstruction, patch the; WARNING; • When using a keyhole saw or cutting

6 En Eng lish INSTALLATION This is the recommended installation procedure when the material of the installation location is plasterboard. How to install 1 Position the cutout template where you are installing the speaker. 2 Trace a line around the template with a pencil. The mark for the center of t...

Page 8 - “CONNECTING YOUR AMPLIFIER/; Place the speaker into the ceiling.; • When installing the speaker, do not

7 En INSTALLATION 6 Pull the speaker cable out of the hole which you have cut. • Leave some extra length of cable when pulling the cable out. 7 Connect the speaker cable to the speaker. • For detailed instructions, refer to page 9 “CONNECTING YOUR AMPLIFIER/ RECEIVER” . 8 Place the speaker into the ...

Page 9 - • When tightening the screws, do not; • As several magnets are on the; • Be very careful when removing the

8 En Eng lish INSTALLATION Tighten screws until the mounting clamps sufficiently grip the ceiling. Tighten the screws firmly to secure the speaker to the ceiling. CAUTION • When tightening the screws, do not screw too tightly. This may cause breakage of the mounting clamps and fracture of the wallbo...

Page 10 - Release the terminal.; • Do not let the bare speaker wires

9 En Before making connections, make sure that the amplifier/receiver is switched off. • When connecting, also refer to the owner’s manual of the connected equipment. • Connect the push input terminals at the rear of the speakers to the speaker output terminals of the amplifier/receiver with the spe...

Page 11 - CONNECTING YOUR AMPLIFIER/RECEIVER; After connecting; Apply the paint to the grille.; • Make sure that the grille holes remain; PECIFICATION

10 En Eng lish CONNECTING YOUR AMPLIFIER/RECEIVER • Lower the power amplifier/receiver volume control before changing input sources. Never change input sources (for example, FM to CD) at high listening levels. Always turn the receiver/amplifier unit off when installing or removing any cables. • Anyt...

Page 15 - Condizioni della garanzia

i It Garanzia limitata per l’Area Economica Europea (AEE) e la S vizzera Vi ringraziamo per aver scelto un prodotto Yamaha. Nel caso raro in cui il vostro prodotto abbia bisogno di riparazioni in garanzia, entrare in contatto con il negozio in cui era stato acquistato. S e si avessero difficoltà, en...