Yamaha FZ- Manuals

Step 7: Pull the two pieces of plastic apart on the rear tail on both sides to give room to access (4) 8mm bolts on each side

Step 10: Remove (2) 10mm nuts holding tail light assembly bracket on Step 11: Carefully remove the bracket so that disconnecting the white connector is easier.

Section 2: Removing Stock LED PCB from Tail Light Step 1: Remove (2) 4mm Allen bolts to remove the metal tail light assembly bracket

Step 4: Remove the outer black housing from the inner one by pressing in all the (6) tabs gently with a flathead screwdriver (See picture below for tab locations)

Step 6: Place the remaining enclosure on a non-metallic container and place on the top rack of the oven. Step 7: Turn the oven heating element off and allow the enclosure to sit in the oven for 15 minutes Warning: The plastic enclosure will be hot when taken out of the oven ( duh ). Use some kind of...

Step 10: After separating the two pieces make sure that no sealant is left on the outside surfaces of the lens or enclosure plastic. Once the sealant cools it will be very strong and almost impossible to remove without reheating. Step 11: After the enclosure has cooled, use a Phillip’s screwdriver t...

Section 3: Adding Lupus Lights PCB to the Tail Light Step 0: TIP: If you’d like to reuse the OEM grommet, you will have to “gut” it to allow you to pass the connectors through. We used an Exact-O knife to get the desired result. If you don’t want to spend the time gutting the OEM grommet, simply fil...

Tip: If reusing the OEM grommet, make sure you reinsert it and twist to secure it! Step 3: Screw in (2) black Phillips screws to hold the circuit board down

Resealing Procedure There are a few ways to reseal the LED lens to the enclosure. They are described as follows: A. Use of an RTV Silicon : Place the two halves of the enclosure on the top rack of the preheated oven set to 260 degrees F for 10 minutes. Please make sure the oven heating element is tu...

Section 4: Placing Modified Tail Light on Motorcycle Step 1: Plug in the center white running/brake light connector.

Step 2: Reattach the tail light to the rear of the motorcycle using the bolts removed from Sec. 1: Step 10 Step 3: Plug in both turn signal connectors (they are color coded so just match the colors of the connectors you have been shipped)

Step 4: Reinstall the seat lock bracket using the (4) 8mm bolts from Sec 1: Step 8 Step 5: Reinsert the two pieces of plastic on both sides of the rear tail (reverse of Sec 1: Step 7 )

Step 8: Reinstall (2) 10mm bolts from Sec 1: Step 4 Step 9: Reconnect the battery to the electrical system.

Step 11: Turn on the motorcycle, test the operation of running lights, brake lights, and turn signals. Step 12: Pat yourself on the back… you did it! Enjoy your awesome integrated LED tail light! We would love to get feedback and installation photos! Please send any comments or critiques on how we c...