Xantech PA635 - Manuals

Xantech PA635 – Manual in PDF format online.

Manuals:

Manual

Manual Xantech PA635

Summary

Page 2 - GENERAL INFORMATION; Figure 1

Page 2 Model PA635 © 2001 Xantech Corporation. GENERAL INFORMATION To enhance the ease of installation and obtain optimum performance from the PA635, we recommend that you first become familiar with all its features and special capabilities by studying the descriptions and instructions in this manua...

Page 3 - – PA635 Front Panel – Features and Functions

Model PA635 Page 3 © 2001 Xantech Corporation Individual ON/OFF of Amp Pairs . Permits Standby ON/OFF control of individual channel pairs. Specifically, it permits the STATUS outputs (12 Volts On/Off) of Xantech ZPR68 zones to switch the Standby of the PA635 channel pairs ( CI ) On and OFF with zone...

Page 4 - – PA635 Rear Panel – Features and Functions

Page 4 Model PA635 © 2001 Xantech Corporation. NOTE: The PA635 may also be powered ON/OFF with an external AC line switch into which the power cord of the PA635 is plugged (such as the switched AC outlet of a preamp, timer, etc. with a 10A rating). For this type of operation, leave the POW ER switch...

Page 7 - Applicable RC68+ Button Descriptions; – The RC68+ Programmer; IR Emitter Lens; Button; OFF Command

Model PA635 Page 7 © 2001 Xantech Corporation Applicable RC68+ Button Descriptions 1 A B C ADJ-OFF 1 2 3 4 5 6 7 8 GLOBAL Z-ADJ TREBLE VOL MUTE ON OFF E-FLAT LAST MAX-V TRIM OFF C-BAL BASS INPUT A RC68+ PROGRAMMER 80 48 10 90 01 00 C0 50 D0 41 40 A0 30 B0 21 20 E0 70 F0 61 60 88 18 98 09 08 A8 38 B8...

Page 8 - Balance Commands; amplifier pairs and collectively as a group.; Be sure to set the RC68+ to the same number!; Refer to the RC68+ instructions for code group setting procedures.

Page 8 Model PA635 © 2001 Xantech Corporation. 4. C-BAL Command . Instantly returns the balance to the Center position (equal volume in each channel) from any previous setting. 5. Balance Commands . W hen the Balance "arrow" buttons are pressed, the audio output will move to the left or righ...

Page 9 - INSTALLATION - PHYSICAL LOCATION AND MOUNTING; – Horizontal Mounting; NOTE; or when located in seismically-active areas.

Model PA635 Page 9 © 2001 Xantech Corporation INSTALLATION - PHYSICAL LOCATION AND MOUNTING W hen you mount the PA635, you should plan its location carefully. Pay attention to each of the following factors: Upper shelf, component, wall, etc. 2-inch spacing (minimum) PA635 To maximize air flow, route...

Page 10 Model PA635 © 2001 Xantech Corporation. CONNECTING THE PA635 W hen making connections to the PA635 be sure the power cord is unplugged. Proceed as follows: COMMON LOCAL CI GROUND ST ATUS IR IN STEREO MONO BRIDGED MODE LEFT RIGHT SPEAKER + -- -- + + BRIDGED -- LEFT RIGHT 1 VIDEO AUDIO L R 1 R...

Model PA635 Page 11 © 2001 Xantech Corporation CAUTION : After lead ends are inserted and the screws tightened down, be sure there are no free strands that could cause shorting! Speaker Phasing To obtain stable imaging and full bass response, it is imperative that stereo speakers be connected "i...

Page 13 - Smart; Smart; Figure 8; – Basic PA635 and RS41AV System – Requires Room-Dedicated Remotes

Model PA635 Page 13 © 2001 Xantech Corporation WARNING TURN POWER OFF BEFORE CHANGING MODES CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN REMOTE MASTER ON/OFF CONTROL 5-30 VOLTS DC LEFT RIGHT COMMON AUDIO BUS + -- CI GROUND ST ATUS IR IN COMMON LOCAL CI GROUND ST ATUS IR IN STEREO MONO BRIDGED MODE LE...

Page 14 - A Basic Dedicated IR System - Non-Dedicated Keypads and Remotes.

Page 14 Model PA635 © 2001 Xantech Corporation. CAUTION: When changing the group numbers, you must connect an IR receiver to each amplifier pair's IR input (item 11, Fig. 3) one at a time. You cannot use the Common IR Input (item 15, Fig. 3) as this will change them all to a different, but same numb...

Page 15 - Figure 9

Model PA635 Page 15 © 2001 Xantech Corporation WARNING TURN POWER OFF BEFORE CHANGING MODES CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN REMOTE MASTER ON/OFF CONTROL 5-30 VOLTS DC LEFT RIGHT COMMON AUDIO BUS + -- CI GROUND ST ATUS IR IN COMMON LOCAL CI GROUND ST AT US IR IN STEREO MONO BRIDGED MODE L...

Page 16 - Connecting the REMOTE MASTER ON/OFF CONTROL Terminals; must; white striped; – Using the Remote Master On/Off Control Terminals

Page 16 Model PA635 © 2001 Xantech Corporation. Connecting the REMOTE MASTER ON/OFF CONTROL Terminals As mentioned under "PA635 PANEL AND FEATURE DESCRIPTIONS", the REMOTE MASTER ON/OFF CONTROL terminals allow the power to the entire PA635 to be turned ON and OFF by a remotely applied DC Vol...

Page 18 - TROUBLE SHOOTING; Sound cuts in and out every 3 to 5 seconds.

Page 18 Model PA635 © 2001 Xantech Corporation. TROUBLE SHOOTING If you encounter a problem, please review the items in the following list. Be sure, in addition, to check other system components, such as preamplifiers, CD players, speakers, speaker wiring, etc., that may be at fault. PROBLEM PROBABL...

Page 19 - Short term continuous, one pair driven at 1 kHz, at rated THD; and

Model PA635 Page 19 © 2001 Xantech Corporation PA635 SPECIFICATIONS Number of channels 6 Power Output Rated continuous power, each channel, all six channels simultaneously driven, 20 Hz to 20kHz, at rated THD 35 W atts at 8 Ohms Power Output Short term continuous, each channel, 2 channels driven, 1 ...