Xantech D5KP - Manuals

Xantech D5KP – Manual in PDF format online.

Manuals:

Manual

Manual Xantech D5KP

Summary

Page 2 - Safety Information; IMPORTANT SAFETY INFORMATION

- 2 - Safety Information CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the prese...

Page 5 - Defining Terms; Zone

- 5 - Defining Terms Zone A Zone is defined as an area of the house that has separate source selection capabilities from all other areas of the house. Typically, a zone is comprised of a single room, but it is possible for a zone to spread across multiple rooms (kitchen/dining room, master bedroom/m...

Page 6 - D5KP Amplifier Keypad to Speakers

- 6 - Pre-Wiring D5RH and D5SH, D5SH4 Digital Audio Distribution Hub to D5KP Amplifier Keypad The D5SH4 and all associated components are wired using CAT-5 terminated to the T-568A Wiring Standard (Figure 2.1). When pre-wiring, run lengths of CAT-5 from the pre-determined R5RH and D5SH, D5SH4 Digita...

Page 7 - D5IP Local Sources to the D5KP Amplifier Keypad

- 7 - D5IP Local Sources to the D5KP Amplifier Keypad Local sources are only available within the area that they are installed. They will not be available to other areas of the house as they are not distributed by the D5RH, D5SH, or D5SH4. Run lengths of CAT-5 from any local (in-room) source to the ...

Page 8 - ITEM DESCRIPTION

- 8 - D5KP - FRONT Figure 2.1: Front of D5KP Keypad ITEM DESCRIPTION 1 OLED Screen 2 SOURCE Selection 3 VOLUME Selection 4 MUTE Button 5 IR ‘Eye’ 6 MAIN Button 7 POWER Button 8 VOLUME BAR Indicator

Page 9 - Speaker

- 9 - D5KP - REAR L+ L- R+ R- + - 4 1 5 2 3 Figure 2.2: Front of D5KP Keypad ITEM DESCRIPTION 1 SYSTEM RJ-45 Port 2 Speaker Output Connector 3 AUX Power Connector 4 LOCAL RJ-45 Port 5 External IR Input Jack

Page 10 - Installation

- 10 - Installation The D5KP is designed to mount in a standard single-gang rough-in box (J Box). Typical mounting height is 56-60” from the floor to the bottom of the frame. This provides optimum viewing for the largest number of people. Note: Do not mount the D5KP in the same rough-in box as high ...

Page 11 - ZONE OUT – D5RH; D5KP Rear

- 11 - 3. Connections ZONE OUT – D5RH The ‘ZONE OUT’ RJ-45 connector’s interface with D5KP Amplified Keypad through CAT-5 cables wired to the T-568A Standard. These connectors carry IR information from the keypad as well as audio information to the D5KP Amplifier Keypad. Status information is also c...

Page 12 - ZONE OUT – D5SH, D5SH4

- 12 - ZONE OUT – D5SH, D5SH4 The ‘ZONE OUT’ RJ-45 connector’s interface with D5KP Amplified Keypad through CAT-5 cables wired to the T-568A Standard. These connectors carry IR information from the keypad as well as audio information to the D5KP Amplifier Keypad. Status information is also carried b...

Page 13 - Auxiliary Power Connector (AUX POWER OUT) – D5RH and D5SH, D5SH4

- 13 - Auxiliary Power Connector (AUX POWER OUT) – D5RH and D5SH, D5SH4 For wire runs over 150’, it is recommended to run an additional 16 AWG/2-conductor wire from the head-end location to the Amplified Keypad locations. This will allow the AUX POWER OUT terminals to supply additional power to the ...

Page 14 - SERIES; D5IP Source Input Wall Plate; External IR Receiver Connections; Figure 3.3: D5KP to External IR Connections

- 14 - 291D SERIES D5KP Internal Wire Colors White IR OUT Black GND Red +12V D5IP Source Input Wall Plate Interconnecting between the D5KP and the D5IP Source Input Plate consists of plugging in a CAT-5 cable terminated to an RJ-45 connector wired to T-568A standard (see Figure 2.0) to the RJ-45 jac...

Page 15 - Internal IR Receiver; ITEM

- 15 - Internal IR Receiver The internal IR receiver is located beneath the ‘X’ button. The internal IR receiver can receive and respond to commands from the D5MR (mini-remote control) and the D5LR (learning remote control). It will also pass-thru IR remote control commands to audio sources via an e...

Page 16 - D5KP Speaker Connections; Ensure that system power is OFF!

- 16 - D5KP Speaker Connections The D5RH and D5SH, D5SH4 routes digital audio to connected D5KP Amplifier Keypad where the audio is then amplified and sent to in-room speakers. WARNING!: The D5KP’s amplifier is capable of powering a single pair of 8-6 Ohm speakers. DO NOT connect speakers with a rat...

Page 17 - D5KP Installer Setup; Figure 4.0: D5KP Keypad Parameter Buttons; User Parameters; ”, press the “X” MAIN button for 3 seconds and a menu will appear.; Setup Parameters; ”, remove the trim plate and press the setup switch.

- 17 - 4. D5KP Installer Setup The D5KP Installer Setup is defined into two categories, “User Parameters” and “Setup Parameters”. User Parameters allows the end-user to change the keypad functionality to his or her needs. Setup Parameters are for the installer to custom create an installation based ...

Page 18 - USER PARAMETERS; BASS

- 18 - USER PARAMETERS BASS The “bass” control allows the sound to be adjusted on the lower frequency range. Using the volume bar as an indicator, the central position shows the default position. Moving the indicator to the left side lowers the bass, reducing the volume of the low frequency sound. M...

Page 20 - SETUP PARAMETERS; SOURCE NAMES

- 20 - SETUP PARAMETERS SOURCE NAMES The source names can be changed. Select the source name that is to be changed and press the “X” button. Be default, the source names are “SRC 1”, “SRC 2”, “SRC 3”, “SRC 4”, and “LOCAL”. Use the VOLUME buttons to move the ‘underlining’ cursor to the character that...

Page 23 - Xantech Limited Warranty

- 23 - Xantech Limited Warranty (Effective for products sold after July 1, 2006) Xantech Corporation (“Xantech”) warrants to the holder of a valid proof of purchase as the first end-user purchaser (“You”), its products to be free from defects in materials and workmanship for the periods specified be...

Page 24 - Specifications

- 24 - Specifications Sampling Frequency 48kHz Audio Resolution 24 Bit, Stereo Output Power 30 Watts Per Channel THD + Noise Full Scale 0.06% Dynamic Range 96dB Frequency Response 20Hz-20kHz +/- 0.1dB Dimensions D x W x L 2.62" x 1.8" x 4.07" (66.5 mm x 45.7 mm x 103.4 mm) Weight 6 oz. U...