Winegard RTS-80B - Manuals

Winegard RTS-80B – Manual in PDF format online.

Manuals:

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12

Summary

Page 2 - Parts Included • Tools Needed • Unpacking the Unit; USE 2 PEOPLE; TOOLS NEEDED FOR UNPACKING & INSTALLATION:; products or services.; For Winegard Warranty Information:; Attn: Technical Services; If using knife to open

2 Parts Included • Tools Needed • Unpacking the Unit 1 Dome 1 base with electronics, dish, dual LNBF *Aftermarket versions also include all mounting hardware and cabling required for a single receiver installation PARTS INCLUDED*: USE 2 PEOPLE when removing the unit from the carton. ! DO NOT PAINT D...

Page 3 - FIGURE 1; Quick Reference Guide; This model is PRESET for DIRECTV receivers.; If you have a; or; receiver, you must change; Install in DRY conditions only!; RoadTrip Minimax; FIGURE 2; MUST face REAR; TO CHANGE SWITCH SETTINGS FOR DISH

3 DISH NETWORK HYBRID 1 2 3 4 5 6 7 8 0 = UP 1 = D O W N KEY BELL TV 1 2 3 4 5 6 7 8 FIGURE 1 4. After selecting location for unit (see Step 2), place the unit on the centerline of the vehicle. 5. Position base so that cables exit toward the rear of vehicle. The distance from the edge of the roof to...

Page 4 - Cable entry installation —; NICKS OR CUTS IN WIRING JACKET MAY

4 7. Clean roof area where the base feet will be attached to the roof. Do not erase your marks! 8. Put approved sealant in the areas marked for the base feet. Place base feet on top of the sealant and screw down with the (3) #10 screws for each foot. 9. After all base feet are secured to roof, put s...

Winegard Manuals