Winegard MV-1111 - Manuals - manualsarea.com

Page 2 - Introduction; and processing take place.; DIRECTV; Introduction/How Does Digital Satellite TV Work?

2 DIRECTV ® is an official trademark of DIRECTV, a unit of GM Hughes Electronics Corporation. DISH Network TM is an official trademark of EchoStar Communications Corporaton. DIGITAL BROADCAST SYSTEMSATELLITE(S) Introduction Congratulations! You have purchased one ofWinegard’s latest developments in ...

Page 3 - Parts Included • Tools Needed • How to Unpack; About this manual —; Indicates caution should be taken!; TOOLS NEEDED FOR UNPACKING & INSTALLATION:

3 2 Cable clamps1 Cable entry plate1 large yellow spade connector2 small red spade connectorsAll required screws and washers1 base with electronics, dish, stacked LNBF1 tube silicone 1. Open box and remove packing material. 2. Lift unit out of box vertically. Do not turn box and“roll” out, or turn u...

Page 4 - Installation Diagram; REAR BASE FOOT; MUST DIRECTLY; FACE REAR OF; Remove wire ties

4 Installation Diagram FIGURE 1 ADJUSTABLEBASE FOOT REFLECTOR REAR BASE FOOT MUST DIRECTLY FACE REAR OF VEHICLE SWITCHLOCATION POWER SUPPLY AZ MOTOR COUNTERWEIGHT Remove wire ties holding mount EL MOTOR LEVELINGSCREW ADJUSTABLEBASE FOOT LEVELINGSCREW LEVELINGSCREW HEYCO ® CONNECTORS GPS ANTENNA REAR...

Page 5 - Installation; Installing unit on roof of vehicle —

5 6. On each foot, screw the flange nut to the base ofthe leveling screw on the mounting foot, flange up.Place rubber washer, with the rubber side up, onthe nut, Figure 2. Push mounting foot under base.Push foot screw through the base and tighten locknut to secure foot to base. Be sure the base feet...

Page 6 - ROOF INSTALLATION, continued; Place the unit on the roof in its permanent location; GPS installation —

6 123456789012345678901234567890121 123456789012345678901234567890121 123456789012345678901234567890121 123456789012345678901234567890121 123456789012345678901234567890121 123456789012345678901234567890121 10. Clean roof area where the base feet will beattached to the roof. Do not erase your marks!1...

Page 7 - Cable entry installation —; Installation • Wiring; INSTALLING THE POWER SWITCH; WINEGARD 12 VDC POWER FILTER; INSTALLATION; Connect yellow spade connector to silver spade on switch.; INSTALLING THE POWER SWITCH DIAGRAM

7 CABLE-ENTRYPLATE CABLE CLAMP -EVERY12”-16” 1. Decide the best location for the cables to enter thevehicle, and the location of the switch and receiver(see “Installing the switch and receiver” below.) Drilla 1/2” hole in the roof, push wires inside. Makeproper connections (remember you must have fi...

Page 8 - Connecting two receivers; Connecting first receiver:; Connecting one receiver; Connecting the receiver —; How to apply silicone —

8 WIRING TWO RECEIVERS SECONDARY SATELLITE PRIMARY RECEIVER SATELLITE INPUT NOT USED INPUT IN OUT OUT SP-2052 SAT RECEIVER D575p DEMULTIPLEXER DEMULTIPLEXER DC BLOCK RECEIVER Initializing & replacing the dome afterconnecting the receiver(s) — 1. Park vehicle where it is free of all obstructions ...

Page 9 - Operation; lite receivers; To operate your system —; DIRECTV programming; Your system is now set up to toggle between; ODD EVEN ODD EVEN

9 Operation Your new MV-2222/1111 features: • GPS technology• Fast signal acquisition times• Easy “one-button” operation• Ability to toggle between satellites using remote control, if subscribing to multi- satellite programming NOTE: For Model MV-1111 vehicle must be parked.1. Turn on receiver and t...

Page 10 - PROBLEM; The GPS is not acquiring a signal.; Check switches to make sure they are set correctly.; Troubleshooting

10 Signal strength screen meter shows somesignal strength, but constantly moves up anddown, and is never locked on satellite. Unit continues to move, but never finds any signal. Have signal strength on the even or odd transpon-ders, but not on both transponders. The unit continues to move and the si...

Page 11 - Base Diagram

11 Base Diagram FIGURE 9 TO RECEIVER TO LNBF CONTROL BOX DETAIL DO NOT USE AZ MOTOR EL MOTOR 8-PIN POWER T A s:\part-no\1021p11 CONTROL BOX (DETAIL BELOW) POWER SUPPLY #1 POWER SUPPLY (POWER WIRE, SEE DETAIL) #4 COAX CABLE ATCONTROL BOX #3 CONTROLBOX TO LNBF EL MOTOR #2 LNBFVOLTAGE HEYCO CON-NECTORS...

Page 12 - TWO YEAR LIMITED WARRANTY; Specifications & Warranty; Features and specifications

12 Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601 • 319/754-0600 Fax 319/754-0787 • www.winegard.com Printed in U.S.A. © 2002 Winegard Company 2451021 Rev. 1/06/03 TWO YEAR LIMITED WARRANTY Winegard Company warrants this Winegard product (excluding receiver) against any defects in ma...