Weider WESY19510 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS

2 TABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

Page 4 - BEFORE YOU BEGIN

4 BEFORE YOU BEGIN ASSEMBLED DIMENSIONS: Height: 76 in.Width: 37 in. Length: 48 in. Foot Plate Low Pulley Station High Pulley Station Left Side Right Side Lat Bar Decal 1 Decal 2 Leg Lever Butterfly Arms Press Arm Preacher Pad Weight Stack Seat Backrest Weight Pin Thank you for selecting the versati...

Page 5 - Frame Assembly; ASSEMBLY

5 1 56 High Side of Bracket 3 5 51 51 14 1 27 4 1. Before beginning assembly, be sure that youhave read and understand the information inthe box above. Press a 2” Square Outer Cap (51) onto each endof the Stabilizer (5). Press a 2” Square Inner Cap(27) into the end of the Base (4). Insert two 5/16” ...

Page 7 - Arm Assembly

7 5. Press the Weight Tube Bumper (64) into the endof the Weight Tube (63). Insert the Weight Tubeinto the stack of Weights (25). Be sure that thepins on the Weight Tube are resting in the pingrooves in the upper Weight. Lubricate the insides of the holes in the TopWeight (76). Set the Top Weight on...

Page 9 - Cable Assembly

9 11. During steps 11 through 24, refer to the CABLE DIAGRAM on page 20 of this manual to verifyproper cable routing. Before beginning this sec-tion, identify the Long Cable (23) and the ShortCable (58) by comparing the lengths of thecables. IMPORTANT: While assembling the cables, donot overtighten ...

Page 13 - Seat Assembly

24. Attach the Long Cable (23) to the Small “U”- Bracket (67) with a 1/4” Nylon Locknut (2) and a1/4” Flat Washer (10). See the inset drawing. Do not overtighten the Nylon Locknut; itshould be threaded onto the end of the Cableonly a couple of turns, as shown. Attach the Small “U”-Bracket (67) to th...

Page 16 - ADJUSTMENTS

16 ADJUSTMENTS The instructions below describe how each part of the weight system can be adjusted. Refer to the exerciseguide accompanying this manual to see how the weight system should be set up for each exercise. IMPOR- TANT: When attaching the lat bar or nylon strap, make sure that the attachmen...

Page 18 - WEIGHT RESISTANCE CHART

18 WEIGHT PRESS ARM BUTTERFLY ARM LEG LEVER HIGH PULLEY LOW PULLEY PLATES (lbs.) (lbs.) (lbs.) (lbs.) (lbs.) Top 20 10 15 14 24 1 45 22 36 28 54 2 70 33 54 44 82 3 99 42 75 60 115 4 128 48 96 72 147 5 153 60 115 90 175 6 184 69 137 103 209 This chart shows the approximate weight resistance at each s...

Page 19 - TROUBLE-SHOOTING AND MAINTENANCE

19 TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately. Theweight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type of cable use...

Page 20 - CABLE DIAGRAM

20 CABLE DIAGRAM The cable diagram below shows the proper routing of the Short Cable (58) and the Long Cable (23). Use thediagram to be sure that the two cables and the cable traps have been assembled correctly. If the cables havenot been correctly routed, the weight system will not function properl...

Page 21 - NOTES

Page 23 - EXPLODED DRAWING—Model No. WESY19510

23 11 11 8 8 55 27 12 15 44 15 71 23 27 21 44 21 3 61 60 3 56 15 12 2 57 58 21 3 5 51 14 19 26 51 25 64 63 76 9 21 3 3 4 1 27 65 15 71 41 10 43 3 21 6 50 7 42 7 50 6 21 69 70 69 70 47 48 44 45 44 45 13 40 38 37 18 32 28 30 34 10 2 24 36 30 34 14 11 3 29 34 30 28 9 73 49 49 46 32 30 34 35 49 49 46 22...

Page 25 - REMOVE THIS PART IDENTIFICATION

This chart is provided to help you identify the small parts used in assembly. Important: Some parts may have been pre-assembled for shipping purposes; if you cannot find a part in the parts bags, check tosee if it has been pre-assembled. REMOVE THIS PART IDENTIFICATION CHART FROM THE MANUAL Please N...

Page 26 - PART IDENTIFICATION CHART—Model No. WESY19510

5/16" Nylon Locknut (3) 1/4" Flat Washer (10) 5/16" Flat Washer (8) 3/8" Flat Washer (9) 1/4" x 2 1/2" Screw (43) 5/16" x 1 3/4" Bolt (72) 3/8" Nylon Locknut (21) 1/4" x 2" Screw (24) 3/8" Nylon Jamnut (73) 5/16" x 2 1/2" Bolt (22) 5/16" x ...