Wagner PP119 - Manuals - manualsarea.com

Page 6 - PP119 - Safety Information; Attention: Danger of injury by injection!; Airless units develop extremely high spraying pressures; Danger

6 PP119 - Safety Information Warning! Never put your fingers, hands or any other parts of the body into the spray jet! Never point the spray gun at yourself, other persons or animals. Never use the spray gun without safety guard. Do not treat a spraying injury as a harmless cut. In case of injury to...

Page 7 - Explosion protection

7 PP119 - Safety Information All local regulations in force must be observed.For secure handling of Airless high-pressure spraying units the following safety regulations are to be observed: U Flash point Danger Only use coating materials with a flash point of 21 °C or above without additional heatin...

Page 8 - Suction installations; Components and Description; Figure 1 - Controls and Functions

A minimum distance of 5 m between the unit and spray gun is to be maintained.When working outdoors:Vapors containing solvents may not be allowed to blow toward the unit.Note the direction of the wind. Danger Set the unit up in such a way that vapors containing solvents do not reach the unit and buil...

Page 9 - Priming; Spraying

Assembly Figure 2 - Unfolding the Cart 1. Grab the pail bracket to lift up the sprayer. Lift the leg lock and unfold the legs. 2. Move leg lock down to lock into place. 3. Twist the knob on either side of the cart toward the “UP” arrow until it stops. Lift the handle until the motor housing and hand...

Page 10 - Cleanup; Figure 14 - Short Term Cleanup

10 PP119 Figure 11 - Spraying Technique A) The key to a good paint job is an even coating over the entire surface. Keep your arm moving at a constant speed and keep the spray gun at a constant distance from the surface. The best spraying distance is 25 to 30 cm between the spray tip and the surface....

Page 11 - Cleaning or servicing the inlet valve may be required if; Figure 20 - Folding the Cart; Parts Lists; Item; Accessories

11 PP119 Figure 16 - Cleaning the Spray Gun 1. Make sure the pump is switched OFF (O). Make sure the PRIME/SPRAY knob is turned to PRIME. Unplug the sprayer. 2. Remove spray gun from the paint hose using adjustable wrenches. 3. Unclip the trigger guard (a) from the filter housing (b) by pulling outw...

Page 12 - Disassembly of the Pump Section

Figure 23 - Pump section replacement instructions Kit Part Number 0418716 Danger Always wear protective eye wear while servicing the pump. Be sure to follow the Pressure Relief Procedure when shutting the unit down for any purpose, including servicing or adjusting. After performing the Pressure Reli...

Page 13 - Daily Maintenance

Problem A. The sprayer does not start. B. The sprayer starts but does not draw in paint when the PRIME/ SPRAY knob is set to PRIME. C. The sprayer draws up paint but the pressure drops when the gun is triggered. D. The PRIME/SPRAY valve is on SPRAY and there is flow through the return tube. E. The s...

Page 14 - Important notes on product liability

14 D Wichtiger Hinweis zur Produkthaftung Aufgrund einer ab 01.01.1990 gültigen EU-Verordnung haftet der Hersteller nur dann für sein Produkt, wenn alle Teile vom Hersteller stammen oder von diesem freigegeben wurden,bzw. die Geräte sachgemäß montiert und betrieben werden.Bei Verwendung von fremdem ...

Page 17 - konformitetsdeklaration; Overensstemmelseserklæring; WAGNER Project Pro 119; Declaração de conformidade; WAGNER Project Pro 119

Geschätfsführer Unterschrift Entwicklungsleiter Executive Officer Signature Head of Development Directeur Signature Directeur du developpement Dirigente affaristico Firma Dirigente tecnico Gerente Firma Jefe de Desarrollo Directeur Handtekening Chef ontwikkeling Forretningsfører Underskrift Udviklin...