US Stove Company 5500XL - Manuals

USSC 5 INSTALLATION OPTIONS Read this entire manual before you install and use your King/Ashley stove. Failure to follow instructionsmay result in property damage, bodily injury, or even death! (See specific installation details for clearances and other installation requirements) A Freestanding Unit...

6 USSC Installation CLEARANCES Your King/Ashley stove has been tested and listed for installation in residential, mobile home, and alcove applications inaccordance with the clearances given in FIGURES 3-5 and TABLE 1. NOTE: Distance “C” on the left-hand side of your King/Ashley stove may need to be ...

USSC 7 Installation VENTING REQUIREMENTS Install vent at clearances specified by the vent manufacturer. Do not connect the pellet vent to a vent serving any other appliance or stove. Do not install a flue damper in the exhaust venting system of this unit. The following installation guidelines must b...

8 USSC Installation VENT TERMINATION CLEARANCES: A) Minimum 4-foot clearance below or beside any door or window that opens. B) Minimum 1-foot clearance above any door or window that opens. C) Minimum 3-foot clearance form any adjacent building. D) Minimum 7-foot clearance from any grade when adjacen...

USSC 9 Installation THROUGH THE WALL INSTALLATION (RECOMMENDED INSTALLATION) To vent the unit through the wall, connect the pipe adapterto the exhaust motor adapter. If the exhaust adapter is atleast 18-inches above ground level, a straight section ofpellet vent pipe can be used through the wall. Yo...

10 USSC Installation OUTSIDE AIR SUPPLY (optional) Depending on your location and home construction, outside air may be necessary for optimal performance. Metal pipe (solid or flexible) must be used for the outside air installation. PVC pipe is NOT approved and should NEVERbe used. A wind shield ove...

USSC 11 Do not operate your stove with the viewing door open. The auger will not feed pellets under thesecircumstances and a safety concern may arise from sparks or fumes entering the room. This heater is designed and approved for premium hardwood pellet fuel only. Any other type of fuel burnedin th...

12 USSC CONTROL PANEL Turning the stove OFF/ON, as well as adjustments for the fuelfeed rate and room air fan speed are performed by pressingthe appropriate button(s) on the control panel which is locatedon the lower left-hand side of your King/Ashley stove (see FIGURE 10). Pressing the “ON” button ...

USSC 13 SHUT DOWN PROCEDURE Press the “OFF” button on the control pad to put the stove in shut down mode. At this time, the red light above the pad will illuminate. Once this is done, the auger will stop feeding pellets, but the room air fan, exhaust blower, and bottomauger will continue to operate....

14 USSC Maintenance Operation DAILY OPERATION The hopper and stove top will be hot during operation; therefore, you should always use some type of handprotection when refueling your stove. Never place your hand near the auger while the stove is in operation. This unit should be filled when the hoppe...

USSC 15 INTERIOR CHAMBERS Periodically remove and clean the burnpot and the area inside the burnpot housing. In particular it is advisable to cleanout the holes in the burnpot to remove any build up that may prevent air from moving through the burn pot freely. If a vacuum is used to clean your stove...

16 USSC Trouble Shooting Disconnect the power cord before performing any maintenance! NOTE: Turning the ON/OFF Switch to”OFF” does not disconnect all power to the electrical components of the stove. Never try to repair or replace any part of the stove unless instructions for doing so are given in th...

18 USSC 13 5 11 10 1 10 12 10 6 12 7 8 2 4 3 9 9 9 Parts Diagram/List models 5500 & 5500XL 6 3 4 1 5 7 2 8 9 Item Part No. Title Qty. 1 25490 Door Weldment 1 2 891166 Ceramic Glass 1 3 891185 Glass Retainer, Top 1 4 891186 Glass Retainer, Bottom 1 5 891160 Handle, Door 1 6 891168 Latch, Door 1 7...

USSC 19 Parts List model 5500 & 5500XL Item Part No. Title Qty. 1 86624 Burnpot Assembly 1 2 86625 Housing Assy, Burnpot 1 3 86628 Weldment, Exhaust Duct 1 4 86633 Weldment, Igniter Tube 1 5 80481 Igniter Cartridge 1 6 25506 Weldment, Door Hinge 1 7 69512 Door Assembly 1 8 69518 Hopper Assembly ...

20 USSC THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPENDABLESERVICE FROM YOUR KING OR ASHLEY, AND ENABLE YOU TOORDER REPAIR PARTS CORRECTLY. KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFER-ENCE. WHEN WRITING, ALWAYS GIVE THE FULL MODEL NUMBERWHICH IS ON THE NAMEPLATE ATTACHED TO THE HEATER. WHEN...