Page 2 - UPS Location Warnings; UPS Connection Warnings; Equipment Connection Warnings; SAVE THESE INSTRUCTIONS; Important Safety Instructions
2 UPS Location Warnings • Install your UPS indoors, away from excess moisture or heat, conductive contaminants, dust or direct sunlight. • For best performance, keep the indoor temperature between between 32º F and 104º F (0º C and 40º C). • Leave adequate space around all sides of the UPS for prope...
Page 3 - Suggested Rackmount Installation; Mounting; Suggested DIN Rail Installation
3 Your UPS may be rackmounted in 4- or 2-post racks or on a DIN rail using these suggested mountingprocedures. The procedures are for common rack/rail types and may not be appropriate for all con-figurations. User must determine the fitness of hardware and procedures before mounting. 1 1 2 Attach mo...
Page 4 - Connection; DB9 Port Connection
4 Connection 1 1 Hardwire the UPS’s input to utilitypower and its output to its load. Consult a qualified electrician and follow allapplicable electrical codes and requirements. Your UPS is designed to support only computerequipment. You will overload your UPS if youconnect household appliances, las...
Page 5 - Basic Operation; Buttons
5 Use the POWER button to switch your UPS between its four modes of operation. OFF: No indicator lights are on. The UPS is completely shut down for storage or shipping. If the UPS is connected to AC power, it will start up in STANDBY mode. If the UPS is not connected to AC power and the POWER button...
Page 6 - Indicator Lights
6 Indicator Lights Use the MUTE/TEST button to do two things: SILENCE ALARM: Your UPS has three alarms. The first, the INVERT alarm, emits four short beeps every ten seconds when the UPS is in INVERT mode, to warn you that AC power has failed. The second, the OVERLOAD alarm, emits short, rapid beeps...
Page 7 - Other UPS Features
7 Basic Operation continued AC Power Terminals: These six terminals receive the UPS’s AC input and distribute the UPS’s AC output. See Connection (page 4) foran explanation of how the terminals should be wired. Smart DB9 Port: Your UPS has a DB9 port that may be used to con- nect the UPS to a DB9 po...
Page 8 - Specifications; Storage
8 Storage & Service Before storing your UPS, disconnect all equipment to avoid battery drain, then place the UPS inthe OFF mode by putting it in STANDBY mode, then disconnecting it from utility power (seeBasic Operation). Press the POWER button. The alarm sounds one short beep. The UPS system wi...