Tripp Lite APSX700HF - Manuals

Page 2 - Important Safety Instructions; SAVE THESE INSTRUCTIONS!; • Do not install near flammable materials, fuel or chemicals.; Battery Connection Warnings; into itself this will damage the device and void your warranty.; Operation Warnings; reason. There are no user serviceable parts inside.

2 Important Safety Instructions SAVE THESE INSTRUCTIONS! This manual contains important instructions and warnings that should be followed during theinstallation, operation and storage of this product. Failure to comply will void the warranty. Location Warnings • Install your Inverter/Charger (whethe...

Page 3 - Features; Operating Mode Switch:

3 Features Operating Mode Switch: controls Inverter/ Charger operation. When this switch is set to“AUTO”, connected equipment receivesconstant, uninterrupted utility AC power,with simultaneous charging of connectedbatteries. The “CHARGE ONLY” settingprevents unwanted battery rundown whenthere is no ...

Page 4 - Match Battery Amp-Hour Capacity to Your Application; • STEP 1) Determine Total Wattage Required; Battery Selection; Example; Tools

4 Match Battery Amp-Hour Capacity to Your Application Select a battery or system of batteries that will provide your Inverter/Charger with proper DC voltageand an adequate amp-hour capacity to power your application. Even though Tripp Lite Inverter/Chargersare highly efficient at DC-to-AC inversion,...

Page 5 - Mounting

5 Mounting WARNING! Mount your Inverter/Charger BEFORE DCbattery and AC power connection. Failure to follow theseinstructions may lead to personal injury and/or damageto the Inverter/Charger and connected systems. Tripp Lite recommends that you permanently mount your Inverter/Charger in the configur...

Page 6 - Battery Connection; • Connect DC Wiring:; Battery Configuration; electrical shock hazard.

6 Battery Connection • Connect DC Wiring: Though your Inverter/Charger is a high-efficiency converter of electricity, its rated output capacity is limited by the length and gaugeof the cabling running from the battery to the unit. Use the shortest length andlargest diameter cabling (maximum 2 AWG (6...

Page 7 - AC Connection; Specifications; Operation; Switch Modes

7 AC Connection To avoid overloading your Inverter/Charger, be sure to match the power requirements of the equipmentyou plan to run at any one time (add the total watts) with the continuous output capacity of yourInverter/Charger (see the Specifications section). When figuring the power requirements...

Page 8 - “BATTERY” Indicator Lights; “OPERATION” Indicator Lights; Resetting Your Inverter/Charger to Restore AC Power; Troubleshooting

8 “ LINE” Green Indicator: If the operating mode switch is set to “AUTO”, this light will illuminate continuously while connected equipment is receiving continuous AC powerfrom a utility/generator source. If the operating mode switch is set to “CHARGE ONLY”,this light will flash to alert you that th...

Page 10 - Inverter; Note on Labeling; Battery Wiring

10 Specifications Model: APSX700HF AC Input Connection: IEC 60320 C14 AC Output Connection: IEC 60320 C13 Battery Connection: Hardwire Inverter Continuous Output Capacity (@ 20° C) 700W/700VA Peak Output Capacity (Instantaneous) 1400W DC Input Volts (Nominal) 12 V DC DC Input Voltage Range 10-15 V D...